AmpliVox SW355 Manuel utilisateur

CONTROL PANEL

Electronic Instructions

SW355 Lectern

Your lectern may not contain all of the electronic modules as shown and explained here. Speakers and lectern

microphone are pre-wired. To install gooseneck microphone, pull out connector from microphone holder and

snap microphone into connector. Install back into microphone holder.

NEED HELP? Call 800-267-5486

16 CHANNEL WIRELESS RECEIVER

1. MIC 1: Adjusts volume level of gooseneck microphone

on reading table.

2. MIC 2: Adjusts volume level of microphone plugged

into the MIC 2 input jack on amplifier.

3. AUX: Controls output level of device that is plugged

into the 1/8" jack.

4. BASS: This control cuts or boosts the bass level.

5. TREBLE: This control cuts or boosts the treble level.

RECEIVER / TRANSMITTER SETUP:

• The receiver has its own POWER / VOLUME Control (G). Turn

Power On. A Frequency Channel will appear in the Channel

Display (A). Press Select Buttons (E) to select a channel. Chan-

nel number must match channel number on wireless transmitter.

• MUTE LEVEL (F) is set at half way mark when it leaves the fac-

tory. If speaker sound is breaking up, turn level clockwise with

small screwdriver until condition improves.

• The transmitter bodypack is operated by 1 - "AA" 1.5 Volt alka-

line battery. Slide off battery cover (H) and install battery as

shown. Make certain the battery is fully seated in its compart-

ment so the cover slides in place easily. Battery life with alkaline

batteries is approximately 8 hours of operating time.

• Select a channel (1-16) on side panel (I) using the supplied

screw driver to select channel number. Channel selected

should match channel on receiver. When transmitter and

receiver are set to correct channel the RF indicator (B) will

glow red when transmitter is turned on.

• Plug the Lapel microphone into the Mic Input Jack (K). The

microphone can be clipped to a necktie or other clothing,

using the supplied clip. The lapel mic should be placed under

the chin, as close to the center of the body as possible.

• Slide the power ON/OFF switch (J) to the ON position (the

LED indicator light will illuminate green). Replace batteries

when this LED turns red.

• GAIN SWITCH (L): If you are a soft spoken person then set the

switch to the 10 dB position. If you are a loud speaking person

then set the switch to the -10 dB position. Adjust to prevent dis-

tortion while speaking.

• Channel Display (A)

• RF - Radio Frequency Indicator (B)

• AF - Audio Frequency Indicator (C)

• ASC / IR Auto Channel Select (Handheld Only) (D)

• Select Buttons - Manual Channel Selection (E)

• Mute Level Adjustment (F)

• Volume Control (G)

ABCD

EFG

12345

Wireless Transmitter - Bodypack

Battery Cover

Channel Selector

Top Panel

Recevier

If you are using the AmpliVox S1695 Wireless Handheld Microphone Transmitter, screw off the lower bottom section of mi-

crophone and insert 2 - "AA" 1.5 Volt alkaline batteries.

IMPORTANT: Because the microphone has an AUTO SYNC function, you first select channel you wish to use on the re-

ceiver. Then press the ASC button (D), the IR light will start to flash. Turn on microphone and point end (6) of microphone

at the flashing IR light on receiver and the microphone will auto sync to the same channel as selected on the receiver.

WIRELESS HANDHELD MICROPHONE—MODEL S1695

BATTERIES

1. Hold the body of microphone in hand and twist off

bottom section of microphone.

2. Insert two “AA” batteries.

3. Twist bottom section back on to microphone.

BATTERY STATUS

The life expectancy of the two batteries is about 10

hours. When the “BATTERY” symbol on the display

screen keeps flashing the batteries should be replaced

immediately.

• TURN ON MICROPHONE: Push and hold the

“POWER/MUTE” (3) button until LCD screen

lights up.

• TO MUTE: Press “POWER/MUTE” button twice

to MUTE. Channel number will flash when muted.

Press button again twice to remove “MUTE”.

• TURN OFF MICROPHONE: Push and hold the

“POWER/MUTE” (3) button for 2 seconds to turn

microphone “OFF”.

• SELECT CHANNEL (Manual): Press and hold

the “SELECT” (4) button for 2 seconds until you

only see the word Channel and channel number.

To change channel, when flashing, press the

“SELECT” (4) button until you reach the desired

channel. Flashing will stop after 10 seconds and

channel is now set.

• LOCK / UNLOCK CHANNEL: Push the

“POWER/MUTE” (3) button and “SELECT”

button at the same time to lock or unlock channel.

When locked, channel cannot be changed.

“LOCKED” symbol appears in upper left-hand

corner.

Functions

1) Interchangeable Microphone Head

2) LCD Screen

3) Power / Mute Control Switch

4) Select Button

5) Microphone Input Sensitivity Ad-

justment—is used to set the gain of

microphone. If you are a soft talking

speaker you will need to turn the control

counter clockwise. Turn clockwise if you

are a loud talker. Use plastic screwdriver

that is supplied.

• With main power switch (L) on, press button (M)

to turn Bluetooth pairing on and hold for 4 seconds to

enter into the pairing mode.

• The RED LED (N) will start to flash, searching for a

Bluetooth signal. Search function will stay active for

10 minutes. If no signal is found ,this function will

shut off. During the search function turn on your

Bluetooth device for pairing. On your Bluetooth menu

of your device, choose pin code 0000. Once paired,

red LED will stay on.

• Use this button (0) to move to the next song or

(P) to play previous song. Use (M) to pause.

When paused you will need to press again to

start playing.

• VOLUME CONTROL (L) Use to adjust the volume of

the Bluetooth material.

BLUETOOTH MODULE—MODEL S1500

150 WATT AMPLIFIER

“The Bluetooth® word mark and logos are registered

trademarks owned by Bluetooth SIG, Inc. and any use of

such marks by Amplivox Portable Sound Systems is

under license. Other trademarks and trade names are

those of their respective owners.

• MIC 2: XLR connector for external wired microphone

• AUX IN: 1/8" (3.5mm)connector . Use for connecting

to other electronics.

• LINE OUT: 1/4" connector. Use for connecting to

other electronics.

• EXTERNAL SPEAKER: 1/4" connector. For external

speaker use.

• AMPLIFIER POWER : ON / OFF SWITCH

Front

Back

Amplivox ● 650 Anthony Trail, Suite D, Northbrook, IL 60062 ● Phone: (800)267-5486 ● Fax: (800)267-5489 www.ampli.com

SEPT, 2017

IMPORTANT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, includ-

ing interference that may cause undesired operation.

The unit’s circuitry may cause interference to nearby radios. To prevent interference, either switch the unit off or move

away from the affected radio.

NOTE: This equipment complies within the limits for a class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or tel-

evision reception, which can be determined by turning the equipment off and on, the user is encouraged to try to cor-

rect the interference by one or more of the following measures:

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio / TV technician for help.

NOTE: Shielded cables may be required to be used with this unit to en-sure compliance with the Class B FCC limits.

TROUBLESHOOTING GUIDE

PROBLEM & ITEMS TO CHECK

UNIT WILL NOT TURN ON

• Is unit plugged in?

SOUND IS MUFFLED

• Bass too high

• Treble too low

FEEDBACK: A LOUD SQUEALING, SHRILL OR HOWL-

ING SOUND THAT IS SELF GENERATED

• Feedback occurs when a microphone is too close to

the speaker or the microphone volume is too high, or

the microphone is pointed towards the speaker. It is

also caused by sound reflecting off hard surfaces.

• Reduce or eliminate Feedback by

- Pointing the microphone in a different direction

- Keeping the microphone BEHIND the speakers

- Turn down the volume levels

POWER IS ON, BUT NO SOUND

• Check main volume level.

• If using wireless, be sure receiver and transmitter bat-

tery is installed and both units are turned on.

MICROPHONE SIGNAL IS WEAK

• If microphone has batteries, check batteries.

• Check cables/connectors.

WIRELESS MIC DOES NOT WORK

• Check that transmitter batteries are fully charged and ensure

transmitter is on.

• Does yellow “signal” LED light when transmitter is turned on?

• Are the transmitter and receiver on the same channel?

(1-16)

WIRELESS MIC CUTS IN AND OUT

• Is unit visible (line of sight) from user? If not, move unit into

view when using wireless microphone.

• Does the yellow “signal” LED go out when signal drops out?

Check battery in transmitter.

MAKES BUZZING NOISE

• Check cables – a damaged cable will cause this. Unplug ca-

bles one at a time until buzzing stops.

• Check for Ground loops – use a ground loop isolator where

needed.

NEED HELP? Call 800-267-5486

Ce manuel convient aux modèles suivants

Autres manuels AmpliVox Système de pupitre

AmpliVox

AmpliVox Modular Lectern S250 Manuel utilisateur

AmpliVox

AmpliVox Expediter W330 Manuel utilisateur

AmpliVox

AmpliVox ST3250 Manuel utilisateur

AmpliVox

AmpliVox SN3040 Manuel utilisateur

AmpliVox

AmpliVox S505A Manuel utilisateur

AmpliVox

AmpliVox Patriot SS3040 Manuel utilisateur

AmpliVox

AmpliVox W360 Manuel utilisateur

AmpliVox

AmpliVox SW3250 Manuel utilisateur

AmpliVox

AmpliVox SS124 Manuel utilisateur

AmpliVox

AmpliVox S505 Manuel utilisateur

AmpliVox

AmpliVox SS3230RTA Manuel utilisateur

AmpliVox

AmpliVox Patriot Plus 3045 Manuel utilisateur

AmpliVox

AmpliVox S355 Elite Lectern Manuel utilisateur

AmpliVox

AmpliVox W355 Manuel utilisateur

AmpliVox

AmpliVox SW505A Manuel utilisateur

AmpliVox

AmpliVox S1695 Manuel utilisateur

AmpliVox

AmpliVox SW505 Manuel utilisateur

Manuels Système de pupitre populaires d'autres marques

Califone

Califone Lectern PL-15 Manuel utilisateur

Displays2go

Displays2go LECTFACVFC Manuel utilisateur

Cobra Acoustic

Cobra Acoustic CPA-2009 Manuel utilisateur

LOTRONIC

LOTRONIC BST AMC73 Series Manuel utilisateur

Oklahoma Sound

Oklahoma Sound 800X Manuel utilisateur

Oklahoma Sound

Oklahoma Sound 123 Manuel utilisateur

HoverCam

HoverCam Pilot X Manuel utilisateur

Oklahoma Sound

Oklahoma Sound PS12V Manuel utilisateur

Oklahoma Sound

Oklahoma Sound LWM-7 Manuel utilisateur

Denon Professional

Denon Professional Active-W Manuel utilisateur

Oklahoma Sound

Oklahoma Sound The Orator 800X Manuel utilisateur

SMART

SMART Sympodium L250 Manuel utilisateur

Balt

Balt 89888 Manuel utilisateur

Crestron

Crestron Isys TPS-4500 Manuel utilisateur

Bogen

Bogen MLA40 Manuel utilisateur

Spectrum Industries

Spectrum Industries SLIM Adjustable Lectern 55544 Manuel utilisateur

Denon

Denon Lectern Active Manuel utilisateur

Kindermann

Kindermann SpeechPoint3 Manuel utilisateur