American Standard Cadet Elite 2774E SERIES Manuel utilisateur

INSTALLATION INSTRUCTIONS

752863-100 REV. C © American Standard Inc. 2002

All product names listed herein are trademarks

of American Standard Inc. unless otherwise noted.

HIGH GLOSS ACRYLIC

SHOWN LESS ALL FITTINGS

CADET ELITE™

6' x 42" WHIRLPOOL/BATHING POOL

2774E SERIES

FOR AFTER-SALES SERVICE CALL 1 (800) 442-1902 WEEKDAYS.

72 x 42 x 19-3/4 In.

(1829mm x 1067 mm x 502mm)

137 Lbs. (62 Kg.)

821 Lbs. (372 Kg.)

82 Gal. (310 L.)

66 Gal. (256 L.)

50 x 27 In. (1270 mm x 686 mm)

65 x 33 In. (1651 x 838mm)

13 In. (330 mm)

42 Lbs./Sq. Ft. (203 Kgs/Sq. m.)

27.8

55.5

GENERAL SPECIFICATIONS FOR 2774E WHIRLPOOL

INSTALLED SIZE

WEIGHT

WEIGHT w/WATER

GAL. TO OVERFLOW

MIn. OPERATING GAL.

BATHING WELL AT SUMP

BATHING WELL AT RIM

WATER DEPTH TO OVERFLOW

FLOOR LOADING

(PROJECTED AREA)

PTS.

CUBE (FT3)

WHIRLPOOL ELECTRICAL SPECIFICATIONS

2.1 HP, 14.4 AMPS, 120V.PUMP

THANK YOU...

for selecting an American Standard bath. Your new

bath is shipped to you after careful inspection. The

whirlpool version is completely assembled with pump,

motor, and system piping. All you need to finish the

installation are your selected fittings and electrical

connections for a whirlpool.

To insure maximum performance and pleasure from

this product, please follow the instructions and

cautions.

GENERAL INSTALLATION INFORMATION

Carefully uncrate and inspect your new bath for any shipping damage. If such damage is found, report it to your vendor

immediately.

After inspection and during installation, protect the bath from construction damage. After installation, and before

enclosing with wallboard, tile, etc., water test the unit and check for leaks.

Do not make modifications to the whirlpool system or remove pump from factory mounting. This could adversely affect

the safety and performance of the whirlpool and void the warranty. Do not handle or move the whirlpool by the pump,

motor, or piping system.

Fittings (bath filler, shower arm, etc.) are not provided with the bath and must be ordered separately. Framing and

enclosing materials are provided by others. Check for availability of optional American Standard wall tiling bead

(required for recess installations).

Protect all finished surfaces of the whirlpool during construction and installation using a drop cloth.

WARNING! Do not lift whirlpool by the piping harness at any time.

List of Optional Components (not included):

• Flex-Jet Pulse Jet Kit*

• Flex-Jet Soft Jet Kit*

• E-Z-Install Heater*

• Tile Bead Kit*

• Apron Kit*

List of Required Components (not included):

• Drain* • Bath Filler*

* see your Home Depot Retailer

List of Required Tools and Supplies:

Tools

• Level

• Tape Measure

• Pipe Wrench

• Slip Joint Pliers

• Screw Driver

• Standard

Woodworking Tools

• Personal Safety

Equipment

• Caulking Gun

Supplies

• Nails

• Putty

• Caulking (waterproof)

• 1 x 3 or 2 x 2

Stringers

• Drop Cloth

• 20 amp GFI

Outlet

• Cement, Plaster,

Grout

RECOMMENDED FITTING LOCATION

64 X 330mm (2-1/2 x 13")

FOR PIER OR ISLAND

INSTALLATIONS ONLY

ALT. FITTING

LOCATION #1

1829 mm

(72)

1067mm

(42)

OUTLINE OF CUTOUT

1791mm x 1029mm

(70-1/2 X 40-1/2)

533mm

(21)

464 mm

(18-1/4)

38mm

(1-1/2)

502mm

(19-3/4)

1-1/2 O.D.TAILPIECE

■ LEVELING

STRINGER

NOT FOR

SUPPORT

ROUGH

FLOOR

229mm

(9)

305 mm

(12)

57mm

(2-1/4) (8) JETS

89mm

(3-1/2)

CUTOUT IN FLOOR

FOR DRAIN

PUMP

FINISHED

WALL

305mm

(12)

OPTIONAL TO

FINISHED FLOOR

USUALLY BETWEEN

1651 & 1981mm

(65 & 78) C/L OF

OVERFLOW

102mm

(4)

C/L OF

SPOUT

C/L OF

VALVES

C/L OF

SHOWER ARM

70 mm

(2-3/4) 117 mm

(4-5/8)

1-1/2 N.P.T.M.

THREADS

19 mm

(3/4)

229 mm

(9)

C/L OF

SUPPLIES

C/L OF DRAIN

SEE FITTING

SPECS FOR

DIMENSIONS

(2) AIR VALVES

ON/OFF

SWITCH

PROVIDE ACCESS TO PUMP FOR

SERVICING ON ALL INSTALLATIONS

INTEGRAL

SUPPORT

FEET

IN-LINE HEATER

REMOVABLE

BLANK

1791mm

(70-1/2)

CUTOUT

TYPICAL RECESS INSTALLATION

LEVELING

SURFACE

WATERPROOF

SEALANT

BATH

WHIRLPOOL ONLY:

UNLESS AN ACCESS OPENING OF AT LEAST

12" X 24" (305 X 610MM) IS PROVIDED,

WARRANTY SERVICE WILL NOT BE PERFORMED.

TYPICAL PIER TYPE INSTALLATION

AS DESIRED

1029mm

(40-1/2)

CUTOUT

AS DESIRED

464mm

(18-1/4)

ACCESS PANEL

610mm

(24)

305mm

(12)

610mm

(24)

305mm

(12)

464mm

(18-1/4)

464mm

(18-1/4)

1832mm

(72-1/8)

1029mm

(40-1/2)

1067mm

(42)

TUB WIDTH

LEVELING

STRINGERS

WHIRLPOOL ONLY:

UNLESS AN ACCESS OPENING OF AT LEAST

12" X 24" (305 X 610MM) IS PROVIDED,

WARRANTY SERVICE WILL NOT BE PERFORMED.

INSTALLATION AND FRAMING INSTRUCTIONS

The variety of installations possible for this whirlpool may require framing procedures other than those shown. Locate studs

as required. Ensure roughing-in dimensions are proper, plumb and square. Provisions must be made in all installations for an

access opening for servicing the pump and controls. It is strongly recommended that an additional opening be provided for

access to the drain components.

NOTE: The apron should not be used as the primary access opening.

1. Position the whirlpool into the installation opening and level the deck, shimming the integral support feet as necessary.

Mark the final position of the underside of the deck by tracing a line on to the studs (see Figure 1).

2. Remove the whirlpool and attach a 2 x 4 stringer to the studs, with the top of the stringer touching the traced line.

3. Install drain components to the whirlpool following the manufacturers instructions. Before replacing your whirlpool for final

installation, be certain that an opening has been provided in the sub-floor for the drain. See the roughing-in drawing for

suggested opening size and location dimensions.

4. Replace whirlpool and re-shim the integral support feet, shimming the entire length of the support feet. Secure the shims

using construction adhesive, silicone, mortar or equivalent materials. While not a necessity, the use of a foundation base

consisting of cement (e.g. Sakrete), mortar, or grout will help provide a solid and secure installation.

752863-100 REV. C (2)

TILE

BEAD

STRIP

LEVELING

STRINGER

BATH

ADHESIVE

SEALANT

WALLBOARD

NOTE: Tile bead kit not included and must be

purchased separately.

FIG. 1

ELECTRICAL DIAGRAM

READ AND FOLLOW ALL INSTRUCTIONS

BLACK

WHITE

120 VAC

GND.

SEPARATE

20 AMP GFCI

OUTLET

WHIRLPOOL MOUNTED

AIR SWITCH OR

WALL TIMER

ELECTRICAL INSTALLATION

PUMP/MOTOR

752863-100 REV. C

ELECTRICAL INSTALLATION INSTRUCTIONS

All wiring must be performed by a licensed electrician in accordance with the national electrical code and all other

applicable codes.

WARNING:

When using electrical products, basic precautions should always be observed, including the following:

1. DANGER: RISK OF ELECTRIC SHOCK

Connect only to a circuit protected by a ground-fault circuit interrupter.

2. Grounding is required. The unit should be installed by a licensed electrician and grounded.

3. Install to permit access for servicing.

4. All building materials and wiring should be routed away from the pump body and heater (if equipped).

The whirlpool should be installed on a 120 vac, 20 amp dedicated circuit. The circuit should be hard-wired from the

electrical power supply panel. The circuit must be a three (3) wire circuit from the electrical supply panel. A grounded

neutral wire and a third wire, earth ground, are essential. HEATER EQUIPPED MODELS REQUIRE A SEPARATE 15

AMP MAXIMUM GFCI CIRCUIT.

(3)

WIRE SELECTION GUIDE

752863-100 REV. C

DRAIN CONNECTION AND SYSTEM TEST

Using recommended drain opening, connect whirlpool drain to waste line. Tighten all drain joints securely. Check the

pump couplings and make sure they are hand-tight. Clean the whirlpool and fill with water to a point 2" above the top of

the highest jet. Recheck the pump couplings and make certain that they are not leaking. (Although the pump couplings

are factory tightened and inspected, some loosening may have occured during transit.) Make sure the whirlpool is

connected to the electrical supply and turn the whirlpool on. Check for leaks around all piping connections while the

whirlpool is running.

POST INSTALLATION CLEAN-UP

Remove all construction debris from bath. Tile grout can be removed with a wooden popsicle stick or tongue depressor.

Do not use wire brushes or any other metal implement on bath surface.

Post installation clean-up generally can be completed using warm water and liquid dishwashing detergent. Stubborn dirt or

stains may be removed using granular Spic and Span®mixed with water.

Painter's naphtha can be used to remove excess adhesives and/or wet oil-base paint.

HARSH CHEMICALS SHOULD NEVER BE USED ON ACRYLIC SURFACES.

Abrasive cleaners must not be used since they will scratch and dull the surface. Dulled areas can be restored by rubbing

with a white automotive-type polishing compound and waxing with a liquid wax.

Maximum distance from

fusebox to motor The sizes shown on this

chart are recommendations

for copper conductors

only. Always follow

local and national

electrical codes

50' 100'

115V Power Line

150' 200'

12 10 8 8

(4) SPIC AND SPAN®IS A REGISTERED TRADEMARK OF PROCTER & GAMBLE

Motor

Hi Performance

Rating

2.1

Table des matières

Autres manuels American Standard Baignoire

American Standard

American Standard Ellisse 2705.118 Manuel utilisateur

American Standard

American Standard Hampton 5' x 32" 2425.XXXW-LHO Manuel utilisateur

American Standard

American Standard Savona Corner Whirlpool 2902.028 Manuel utilisateur

American Standard

American Standard Green Tea 6' X 36" Whirlpool and Bathing Pool... Manuel utilisateur

American Standard

American Standard Evolution 2645V Manuel utilisateur

American Standard

American Standard DXV LYNDON D12536-004 Manuel utilisateur

American Standard

American Standard Scala Oval 2645.002 Manuel utilisateur

American Standard

American Standard Heritage 2806.XXXW Series Manuel utilisateur

American Standard

American Standard Colony Oval Whirlpool and Bathing Pool... Manuel utilisateur

American Standard

American Standard Williamsburg Elite 2805E SERIES Manuel utilisateur

American Standard

American Standard Heritage 6' Whirlpool and Bathing Pool... Manuel utilisateur

American Standard

American Standard Cadet w/ Integral Apron Whirlpool and Bathing Pool... Manuel utilisateur

American Standard

American Standard Green Tea 3573.328 Manuel utilisateur

American Standard

American Standard Savona Oval Whirlpool and Bathing Pool... Manuel utilisateur

American Standard

American Standard Williamsburg 2908 Series Manuel utilisateur

American Standard

American Standard Savona Elite 6' Whirlpool 2901EC Manuel utilisateur

American Standard

American Standard Green Tea 3572.328 Manuel utilisateur

American Standard

American Standard Ellisse Elite 2711E Series Manuel utilisateur

American Standard

American Standard CAMBRIDGE 2460.XXXW SERIES Manuel utilisateur

American Standard

American Standard Heritage 5'x42 2805.002 Manuel utilisateur

American Standard

American Standard Standard 2083 SERIES Manuel utilisateur

American Standard

American Standard Solar Bathtub 0163.060 Manuel utilisateur

American Standard

American Standard Ropetwist Bathing Pool 2722.102 LHO Manuel utilisateur

American Standard

American Standard Reminiscence Drop-In Whirlpool 2908.XXXW Manuel utilisateur

Manuels Baignoire populaires d'autres marques

Agua

Agua BARTOLI-66 Manuel utilisateur

PAA

PAA PRELUDE Manuel utilisateur

BETTE

BETTE SILHOUETTE Manuel utilisateur

Kohler

Kohler K-820-GC Guide de démarrage rapide

Oliveri

Oliveri Naples Manuel utilisateur

Lyons

Lyons Elite ETLxx663219 Series Manuel utilisateur

Woodbridge

Woodbridge BJ500 Instructions de montage

Whirlpool

Whirlpool Ariel ARL-702 Manuel utilisateur

TEIKO

TEIKO EXCELLENT DUO Manuel utilisateur

Kohler

Kohler K-1111-H2 Guide de démarrage rapide

agape

agape MARSIGLIA AVAS1075 Manuel utilisateur

Kohler

Kohler K-1151 Instructions de montage

Kohler

Kohler K-1158 Guide de démarrage rapide

Kohler

Kohler K-1244 Instructions de montage

Kallista

Kallista P50045-G5 Instructions de montage

Kohler

Kohler K-1164-HB Guide de démarrage rapide

Kohler

Kohler Hourglass K-1209-LA Guide de démarrage rapide

Ariel

Ariel AM Series Manuel utilisateur