Amana DLG330RAW Manuel

Amana Domestic Gas DryerTechnical Information

September 2002 16021969 Rev. 0

(This technical sheet replaces RT3210013 Rev. 0.)

120 V, 60 Hz Models

DLG330RAW PDLG330RAW DLG330RAW PDLG330RAW1

• Due to possibility of personal injury or property damage, always contact an authorized technician for servicing or

repair of this unit.

• This technical sheet replaces RT3210013 Rev. 0.

• Refer to Service Manual RS3200007 for detailed installation, operating, testing, troubleshooting, and disassembly

instructions.

• Refer to Parts Manual RP3200020 for part number information.

CAUTION

All safety information must be followed as provided in this Technical Sheet and in Service Manual RS3200007.

WARNING

To avoid risk of electrical shock, personal injury, or death, disconnect power to dryer and shut-off gas supply

before servicing, unless testing requires it.

Models DLG330RAW Models DLG330RAW

Power Source Temperature settings 3

Voltage AC 120 VAC Color coded control Electromechanical

Bi-directional

Amperage (Single Unit) 15 A Features

Frequency 60 Hz

Easy AccessOpening X

Motor horsepower 1/3 Reversible door X

Dimensions Upfront lint filter X

Cabinet Front servicable X

Height−overall 43” FabriCaresystem X

Height of cabinet 36” Signal switch X

Width 27”

Depth 28”

Clearance−dryer door 23 1/2”

Weight

Crated 145 lbs.

Component Testing Information

WARNING

To avoid risk of electrical shock, personal injury, or death, disconnect power to dryer and shut-off gas supply

before servicing, unless testing requires it.

16021969 Rev. 0 September 2002

(This technical sheet replaces RT3210013 Rev. 0.)

Illustration Component Test Procedure Results

Thermostat limit

S.P.S.T. −2 terminals

Measure resistance of the following

terminals:

Terminals 1 −2 ..................................

Open at 225°±7°F

Close at 215°±10°F

Continuity < 1 Ω

Thermostat cycling

S.P.D.T. −3 terminals

Measure resistance of the following

terminals:

Terminals 1 −3...............................

Heat thermostat with a small flame

until a distinct click is heard.

Terminals 1 −2...............................

Open at 153°±5°F

Close at 138°±5°F

Continuity < 1 Ω

Thermostat heater Disconnect wire terminals and

measure resistance of terminals.

Terminal to terminal ..........................

2400 ±240 Ω

Door switch

1 −COM

2 −N.C.

3 −N.O.

Measure resistance of the switch:

Door closed

Terminals 1 −3...............................

Door opened

Terminals 1 −2...............................

Continuity < 1 Ω

ON / OFF Signal

switch

Measure resistance of switch

positions:

ON (Closed position) ....................

OFF (Open position)......................

Continuity < 1 Ω

Infinite > 1 MΩ

Signal buzzer Measure resistance of the buzzer:

Terminal to terminal............................

1.2 K −1.4 K Ω

Fabric selector

3 position switch

Place switch in the positions indicated

in the chart.

Measure resistance of the terminals

indicated.

X indicates continuity (< 1 Ω)

Perm

Press/

Regular

Delicate

Fluff

L1-1



L1-2



L1-3



Timer

Verify input and output voltage is

present.

Refer to specific model Technical Sheet

for timing sequence chart and functional

description of the component.

Sensor Remove wires from sensor terminals

Terminal to terminal ..........................

Any indication other than 0 Ω, replace

sensor.

0 Ω

Ignitor Measure resistance of the following:

Terminal to terminal ..........................

45 −200 Ω

Component Testing Information

WARNING

To avoid risk of electrical shock, personal injury, or death, disconnect power to dryer and shut-off gas supply

before servicing, unless testing requires it.

September 2002 3 16021969 Rev. 0

(This technical sheet replaces RT3210013 Rev. 0.)

Illustration Component Test Procedure Results

504091

1 - 3

123

Gas valve

SENSOR

SECONDARY

COIL

HOLDING

COIL

BOOSTER

COIL IGNITOR

Measure resistance of following coils:

Holding coil

Terminals 1 and 2 ..........................

Booster coil

Terminals 1 and 3 ..........................

Secondary coil

Terminals 4 and 5 ..........................

1365 Ω±25 Ω

560 Ω±25 Ω

1220 Ω±50 Ω

40099801

Motor See “Internal Motor Diagram and

Schematic” section.

See following section “Internal Motor

Diagram and Schematic” for correct

wiring contacts.

40111201

Belt Verify belt is not damaged or slipping. Wipe excess oil from cylinder, motor

pulley, and belt, to prevent slippage.

Replace belt if damaged.

502014

Power cord Measure resistance of wires. Continuity should be indicated on each

wire.

501801

Cylinder seal Verify air leakage is not present around

cylinder seal.

Replace seal, if indication of leakage.

501676

Cylinder glide Verify glides are not damaged. Replace all glides when replacing any

glides.

56234

Burner Verify proper operation. Replace if operation of burner is altered.

Internal Motor Diagram and Schematic

WARNING

To avoid risk of electrical shock, personal injury, or death, disconnect power to dryer and shut-off gas supply

before servicing, unless testing requires it.

16021969 Rev. 0 September 2002

(This technical sheet replaces RT3210013 Rev. 0.)

Unplug motor wire terminal from

motor before starting this test.

Continuity exists between switch

terminal 5 and Black wire.

Manually depress actuator.

Continuity broken between

switch terminal 5 and Black wire.

Continuity exists between switch

terminal 6 and Yellow wire.

Manually depress actuator.

Continuity broken between

switch terminal 6 and Yellow wire.

Continuity broken between switch

terminal 1 and switch terminal 2.

Manually depress actuator.

Continuity exists between switch

terminal 1 and switch terminal 2.

Motor switch checks OK.

Inoperative start switch.

Replace switch.

Inoperative start switch.

Replace switch.

Inoperative start switch.

Replace switch.

Start

Terminals

NOTE: Disconnect

Yellow wire from

motor switch

before testing

start terminals.

Run

Terminals

NOTE: Reconnect

Yellow wire to

motor switch

before testing

run terminals.

Heater Circuit

Terminals

YES

Internal Motor Diagram and Schematic

WARNING

To avoid risk of electrical shock, personal injury, or death, disconnect power to dryer and shut-off gas supply

before servicing, unless testing requires it.

September 2002 5 16021969 Rev. 0

(This technical sheet replaces RT3210013 Rev. 0.)

26 4 3 5 1

MAIN

START

ORANGE

CUSTOMER CIRCUIT

OVERLOAD

PROTECTOR

BROWN

BLACK

YELLOW

PUSH TO

START

LINE

SWITCH SHOWN IN START POSITION

R.S.P.C.

26 4 3 5 1

Wiring Diagram and Schematic

WARNING

To avoid risk of electrical shock, personal injury, or death, disconnect power to dryer and shut-off gas supply

before servicing, unless testing requires it.

16021969 Rev. 0 September 2002

(This technical sheet replaces RT3210013 Rev. 0.)

WARNING

Failure to install, maintain, and/or operate this

machine according to manufacturer's

instructions may result in conditions which can

produce bodily injury and/or propertydamage.

FOLLOWING PATENTS:

CANADIAN NO:

THIS MACHINE MANUFACTURED

UNDER ONE OR MORE OF THE

UNITED STATES NO: 5,113,562

OTHER PATENTS PENDING

5,257,448

ORG-12

LIGHT SWITCH

BLK

TIMER KNOB

GROUND TO TERMINAL

GRN/YEL-18

YEL-18

BRN-18

WHT-18

CONNECTION DIAGRAM

RIBBED OR

RIDGED LEAD

BLOCK BRACKET

GROUND TO TERMINAL

GRN-18

CORD

LEAD-IN

IGNITOR

MOTOR

GAS

ORG-18

VALVE

WHT-18

ORG

BLU-18

WHT-18 3

BLU-18 SENSOR

ORG-18

HOUSING

PLUG

RECEPTACLE

BLU-18

GRN/YEL-18

COLOR MARKINGS

INDICATE WIRE GAUGE

disconnection when servicing controls.

Wiring errors can cause improper and

NUMERALS FOLLOWING

"Caution: Label all wires prior to

"Verify proper operation after servicing"

dangerous operation."

TO TOP

GROUND

TO SUPPORT

PANEL

GRN/YEL-18

BLOCK BRACKET

GROUND TO

GRAPHICS PANEL

WHT-18

RED-18

BLK-18

CYLINDER LIGHT

(NOT ON ALL MODELS)

GRY-18

VIO-18

BLK-22

RED-18

DOOR SWITCH

RECEPTACLE

PLUG

RED-18

PNK-18

TIMER MOTOR

BLK-22

TIMER

RED-18

AUTOMATIC

REG/DRY

DRY

TIME

WRINKLE OUT

SIGNAL

FABRIC SELECTOR

BLK

FLUORESCENT LAMP

(NOT ON ALL MODELS)

STARTER

THERMOSTAT

HEATER

PNK-18

RECEPTACLE

PNK-18

THERM.

LIMIT

PLUG

WHT-18

THERM.

PNK-18

CYCLING

VIO-18

ORG-18

WHT

RED

JUMPERSUPPLIED

ON TIMER

START

PUSH TO

PERM PRESS/KNITS

FSWITCH

BLU-18

GROUND

HOUSING

BASE

GROUND

RED

BLU

BLK-18

213L1-3 NO HEAT

BALLAST

VIO-18

REGULAR

PERM PRESS

DELICATE

L1-2

L1-1-2

ORG-12

GRY/BLK-18

SIGNAL

SWITCH

PART NO. 40119302

BRN-18

Wiring Diagram and Schematic

WARNING

To avoid risk of electrical shock, personal injury, or death, disconnect power to dryer and shut-off gas supply

before servicing, unless testing requires it.

September 2002 7 16021969 Rev. 0

(This technical sheet replaces RT3210013 Rev. 0.)

CYLINDER LIGHT

(NOT ON ALL MODELS)

THERMOSTAT

SCHEMATIC

PUSH TO

START

TIMER

SIGNAL MH

SWITCH

SELECTOR

SWITCH

FABRIC

CYCLING

2 1 3

LIGHT

THERMOSTAT

MOTOR

THERMOSTAT

HEATER

BOOSTER

COIL

START

MAIN

TP 4

IGNITOR

FLUORESCENT LAMP

(NOT ON ALL MODELS)

BALLAST

STARTER

LIMIT

HOLDING

SECONDARY

COIL

240 VAC

120 VAC

SWITCH

DOOR

SENSOR

(NO)

(NC)

(COM)

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Amana Séchoir

Amana

Amana NGD4500V Manuel utilisateur

Amana

Amana 53-3772 Manuel utilisateur

Amana

Amana NED5800DW0 Manuel utilisateur

Amana

Amana ned4655ew Manuel utilisateur

Amana

Amana LE 3402 Manuel utilisateur

Amana

Amana NGD4500VQ0 Manuel utilisateur

Amana

Amana 4KNED5800TQ0 Manuel utilisateur

Amana

Amana ned4655ew Manuel utilisateur

Amana

Amana LE4217W/L2 Manuel utilisateur

Amana

Amana LE2500 Manuel utilisateur

Amana

Amana NDG6800AWW Manuel utilisateur

Amana

Amana LE8457W/L2 Manuel utilisateur

Amana

Amana NGD7200TW10 Manuel utilisateur

Amana

Amana TANDEM W10240880A Manuel utilisateur

Amana

Amana Dryer Manuel utilisateur

Amana

Amana NED7033W Manuel de la liste des pièces

Amana

Amana NED4705EW Manuel utilisateur

Amana

Amana LE7101WB Manuel utilisateur

Amana

Amana W10773375B-SP Manuel utilisateur

Amana

Amana NED4800VQ1 Guide de dépannage

Amana

Amana ND-1 Manuel utilisateur

Amana

Amana D2491E3B Manuel utilisateur

Amana

Amana SDE515DAYW Manuel

Amana

Amana LEA10AW Manuel utilisateur

Manuels Séchoir populaires d'autres marques

Bosch

Bosch WTA79200GB Manuel utilisateur

Miele

Miele TWH 780 WP Manuel utilisateur

Asko

Asko T760 Manuel utilisateur

Alliance Laundry Systems

Alliance Laundry Systems 25 Series Manuel utilisateur

Bosch

Bosch Logixx 10 WTB76556GB Fiche technique

STIEBEL ELTRON

STIEBEL ELTRON Ultronic S Mode d’emploi

Electrolux

Electrolux EW2H328R2 Manuel utilisateur

Beko

Beko DS8433RX1M Manuel utilisateur

Dawlance

Dawlance Spinner DS 6000 C Manuel utilisateur

Electrolux

Electrolux TP5080TW Manuel utilisateur

AEG

AEG TR838P4OB Manuel utilisateur

Indesit

Indesit IDV 75 Manuel utilisateur

Infiniton

Infiniton SD-DG85C Manuel utilisateur

BOMANN

BOMANN WT 5019 Manuel utilisateur

Alliance Laundry Systems

Alliance Laundry Systems TMB795C Manuel utilisateur

Asko

Asko T793C Manuel utilisateur

Kenmore

Kenmore 8041 - 5.8 cu. Ft. Capacity Electric Dryer Manuel utilisateur

Frigidaire

Frigidaire CAQE7077KW0 Manuel du propriétaire