Altos R360 F5 SFF Manuel utilisateur

R360 F5

USER’S MANUAL

Revision 1.0

Unlessyourequestandreceivewritten permission from AltosComputer,Inc.,youmaynotcopyanypartofthisdocument.

Information in this document is subject to change without notice. Other products and companies referred to herein

are trademarks or registered trademarks of their respective companies or mark holders.

Preface

About this Manual

This manual is written for professional system integrators and PC technicians. It provides

information for the installation and use of the server. Installation and maintenance should be

performed by experienced technicians only.

Warnings

Special attention should be given to the following symbols used in this manual.

Warning! Indicates important information given to prevent equipment/property damage

or personal injury.

Warning! Indicates high voltage may be encountered when performing a procedure.

Chapter 1: Introduction

Chapter 1

Introduction

1.1 Overview

This chapter provides a brief outline of the functions and features of the SuperServer

120U-TNR. The following provides an overview of the specifications and capabilities.

System Overview

Motherboard

X12DPU-6

Chassis

119UH3TS-R1K22P-T

Processor

Support

Dual P+ (LGA4189) sockets 3rd Gen Intel Xeon Scalable

Memory

32 DIMM slots, DDR4 RDIMM/LRDIMM or Intel Optane PMem 200 Series*

(up to 8TB for DDR4, or up to 8TB of PMem and 4TB DDR4)

Up to 3200MHz; size up to 256GB

* Note: PMem 200 Series are supported on 3rd gen Intel Xeon Scalable Platinum, Gold

and selected Silver processors.

Drive Support

Twelve hot-swap 2.5" SATA/SAS/NVMe hybrid drive bays

Two SuperDOM (disk on modules)

Expansion Slots

Two PCIe 4.0 x16 (FH, 10.5” L)

One PCIe 4.0 x16 (LP)

One PCIe 4.0 x16 (LP, internal)

I/O Ports

LAN ports depend on

One VGA port (rear)

One serial port (rear)

Three USB 3.0 ports (2 rear, 1 front)

System Cooling

Eight heavy duty fans with Optimal Fan Speed Control

Air Shrouds

Power

Two Redundant Power Supplies, 80Plus Titanium level

Default: 1200W

Form Factor

1U; (WxHxD) 17.2” x 1.7” x 29.1” (437x43x739 mm)

Chapter 1: Introduction

Configuration Options

Riser Cards

Ultra Riser cards provide network connections and other capabilities. The customer must

choose one when purchasing the system.

LAN Ports

Description

No NIC

PCIe 4.0 x16 (Internal), four NVMe ports

Two 10GBaseT

Two RJ45, Intel X710-AT2,

PCIe 4.0 x16 (Internal), four NVMe ports

Four 10GBaseT

(two SFP+)

Two RJ45 and two SFP+, Intel X710-TM4,

PCIe 4.0 x16 (Internal), four NVMe ports

Two 25GbE

Two SFP28, Mellanox ConnectX-6,

PCIe 4.0 x16 (Internal), four NVMe ports

Storage Protocols

The storage drive bays can support SATA, SAS, and NVMe in any combination. To enable

SAS and NVMe, additional hardware is required. Once the supporting hardware is installed for

a selection of bays, drives of any storage protocol type can be inserted.

SATA –The default configuration supports up to twelve SATA drives.

SAS –An add-on controller card and cables can support up to twelve SAS drives.

NVMe –The motherboard supports up to ten NVMe drives. The Ultra Riser card supports

two more. Additional cables are required.

Power Supply Options

Watts

80Plus Level

1200

Titanium

Chapter 1: Introduction

1.2 System Features

The following views of the system display the main features. Refer toAppendix B for additional

specifications.

Front View

R360 F5 SFF

Figure 1-1. Front View

Logical Storage Drive Numbers

Item

Description

0-5

2.5" hot-swap SATA/SAS3*/NVMe* drive bays (NVMe from CPU1)

6-11

2.5" hot-swap SATA/SAS3*/NVMe* drive bays (NVMe from CPU2)

* SAS3 and NVMe support requires with additional parts

R360 F5 LFF

USB 3.0 Port

Service/Asset Tag

with BMC Password

Control Panel

Chapter 1: Introduction

Drive Carrier Indicators

Each drive carrier has two LED indicators: an activity indicator and a status indicator. For RAID

configurations using a controller, the meaning of the status indicator is described in the table

below. For OS RAID or non-RAID configurations, some LED indications are not supported,

such as hot spare. For VROC configurations, refer to the VROC section in this manual.

Drive Carrier LED Indicators

Color

Blinking Pattern

Behavior for Device

Activity

LED

Blue

Solid On

Idle SAS or NVMe drive installed

Blue

Blinking

I/O activity

Off

Idle SATA or no drive

Status

LED

Red

Solid On

Failure of drive with RSTe support

Red

Blinking at 1 Hz

Rebuild drive with RSTe support

Red

Blinking at 4 Hz

Identify drive with RSTe support

Red

Blinking with two blinks

and one stop at 1 Hz

Hot spare for drive with RSTe support

Red

On for five seconds,

then off

Power on for drive with RSTe support

Amber

Blinking

Safe to remove NVMe drive

Green

Solid on

Ejecting an NVMe drive

Chapter 1: Introduction

Control Panel

R360 F5 SFF

Information LED HDD

UID Button/LED

BMC Reset NIC LED Power LED Power

Figure 1-2. Control Panel

Control Panel Features

Feature

Description

UID button/LED

BMC reset

The unit identification (UID) button turns on or off the blue light function of the Information

LED and a blue LED on the rear of the chassis.

This button can also be used to reset the BMC.

Information LED

Alerts operator to several states, as noted in the table below.

NIC LED

Indicates network activity on LANs when flashing.

HDD

Indicates activity on the storage drives when flashing.

Power LED

Steady on –Power on

Blinking at 4Hz –Checking BIOS/BMC integrity

Blinking at 4Hz and "i" LED is blue –BIOS firmware updating

Two blinks at 4Hz, one pause 2hz and "i" LED blue –BMC firmware updating

Blinking at 1Hz and "i" LED red –Fault detected

Power button

The main power switch applies or removes primary power from the power supply to the server

but maintains standby power. Hold for four seconds to force a shut-down.

Information LED

Color, Status

Description

Red, solid

An overheat condition has occurred.

Red, blinking at 1Hz

Fan failure, check for an inoperative fan.

Red, blinking at 0.25Hz

Power failure, check for a non-operational power

supply.

Chapter 1: Introduction

Red, solid, with Power LED blinking

green

Fault detected

Blue and red, blinking at 10 Hz

Recovery mode

Blue, solid

UID has been activated locally to locate the

server in a rack environment.

Blue, blinking at 1Hz

UID has been activated using the BMC to locate

the server in a rack environment.

Blue, blinking at 2Hz

BMC is resetting

Blue, blinking at 4Hz

BMC is setting factory defaults

Blue, blinking at 10Hz with Power LED

blinking green

BMC/BIOS firmware is updating

Chapter 1: Introduction

Rear View

Figure 1-3. System: Rear View

System Features: Rear

Feature

Description

Power Supplies

Two redundant power supply modules, PWS1 on the left, PWS2 on the right

LAN ports; specifications depend on your Ultra riser card option

1 to 4

Expansion card slots; see below for details

USB

Two USB 3.0 ports

BMC LAN

BMC LAN port; for indicator details, see BMC LAN LEDs

UID Button/

BMC Reset

UID button and BMC reset button (similar to Control Panel button on previous page)

COM

Serial port

VGA

Video port

Expansion Slots and Riser Cards

This system include riser cards that provide PCIe capabilities—one Ultra Riser card (described

in Section 1.1), one right-facing WIO riser card, and one left-facing WIO riser card.

Riser Card

Slot

Description (all PCIe 4.0)

Ultra Riser card

x16 Internal LP (CPU2)

Right-facing

x16 low profile (CPU1)

Left-facing

x16 FH, 10.5”L (CPU2)

x16 FH, 10.5”L (CPU1)

One riser card slot may be used for a controller card that supports SAS.

USB Ports

Power Supplies

VGA

UID Button/BMC Reset

BMC LAN COM

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Altos Serveur

Altos

Altos BrainSphere T310 F5 Manuel utilisateur

Altos

Altos BrainSphere P530 F4 Manuel utilisateur

Altos

Altos BrainSphere R680 F4 Manuel utilisateur

Altos

Altos R320 F5 Manuel utilisateur

Altos

Altos BrainSphere R385 F5 Manuel utilisateur

Altos

Altos T110 F5 Manuel utilisateur

Altos

Altos BrainSphere T350 F4 Manuel utilisateur

Altos

Altos R380 F5 Manuel utilisateur

Altos

Altos BrainSphere R385 F4 Manuel utilisateur

Altos

Altos BrainSphere R369 F4 Manuel utilisateur

Altos

Altos BrainSphere R365 F4 Manuel utilisateur

Altos

Altos BrainSphere R685 F5 Manuel utilisateur

Altos

Altos BrainSphere R580 F4 Manuel utilisateur

Altos

Altos Altos BrainSphere R365 F5 Manuel utilisateur

Altos

Altos BrainSphere R185 F5 Manuel utilisateur

Manuels Serveur populaires d'autres marques

HP AlphaServer ES47 Manuel utilisateur

Dell

Dell PowerEdge R410 Manuel utilisateur

PowerNAS

PowerNAS CMA Manuel utilisateur

Supero

Supero FatTwin F617R3-FT Manuel utilisateur

MSI

MSI P1-109N-L70 Manuel utilisateur

Dell

Dell PowerEdge XE9640 Manuel

Dell

Dell PS4100 Instructions de montage

EtroVISION

EtroVISION EV3151 Manuel utilisateur

NEC

NEC Express5800/T110j Manuel utilisateur

HP ProLiant Gen9 Manuel utilisateur

Compaq

Compaq ProLiant 3000 Manuel

Dell

Dell PowerEdge 3YPMN Manuel utilisateur

iRobo

iRobo IPC2U Manuel utilisateur

Nortel

Nortel 1000 Con?guration guide Manuel utilisateur

Asus

Asus AP7500 Manuel d'utilisation et d'entretien

Avid Technology

Avid Technology AirSpeed 5000 Manuel utilisateur

HP Integrity rx2600 Guide d'installation

Milestone

Milestone Husky IVO 350T Manuel utilisateur