ALTA LABS AP6-Pro Manuel utilisateur
QUICK START GUIDE
MODEL: AP6-Pro
1
Before You Begin
If you have not already created an account,
visit manage.alta.inc to create your free Alta
Control™ account.
manage.alta.inc
Be sure to also download the Alta Control app
on your mobile device.
2
Package Contents
AP6-Pro Mounting Plate Ceiling Mount
Anchors
(Qty. 2)
Wall-Mount
Screws (Qty. 2)
Ceiling Tile
Screws (Qty. 2)
T-Bar Screws Nuts Rubber Feet
Installation Requirements
• CAT 5/6 Ethernet Cabling
• 24V PoE+ Switch or PoE Injector
• Phillips Screwdriver
• Drill and drill bit for wall or ceiling mounting
3
Hardware Overview
Front
LED
Logo Indicator
Logo Indicator If you need to remove the AP
from the mount, use a flat blade screwdriver to
disengage the Mounting Plate here.
LED Illuminates white by default when AP
is online and functional. Can be changed to
blue or off in the Alta Control software. Flashes
when booting.
4
Back
RESET
PoE
Ethernet Port
Reset Button
Reset Button Press down for 10 seconds until
the LED begins flashing to reset the AP6-Pro
to factory defaults.
Ethernet Port Connects to an Ethernet cable
from your PoE+ Switch. An optional 48V, 0.5A
adapter can be purchased and used to power
the AP6-Pro.
5
Hardware Installation
Ceiling Tile Mount
1. Remove the appropriate ceiling tile.
2. Align the Mounting Plate in the desired
location flat on the tile (typically centered).
Mark the areas indicated below for the
screws and the Ethernet cable.
6
3. Secure the Mounting Plate to the Ceiling
Mount with the ceiling tile between using
the two Ceiling Tile Screws and the two Nuts.
Assembled Top View Assembled Bottom View
Proceed to “Connecting The AP6-Pro” on page 13
7
Wall Mount
1. Position the Mounting Plate in the desired
location and use a pencil to mark the holes.
2. If running cabling along the wall, remove the
notch on the AP6-Pro.
RESET
PoE
8
3. Secure the Mounting Plate to the wall
using the Wall-Mount Screws and a Phillips
screwdriver.
If mounting on drywall, use the anchors to
ensure secure mounting. Use a 6 mm drill
bit to drill the holes for the anchors and
insert them in the wall.
Proceed to “Connecting The AP6-Pro” on page 13
9
T-Bar Ceiling TIle Mount
1. Use a small Phillips head screwdriver to
loosen the two pre-installed screws on the
Ceiling Mount to allow enough clearance for
the T-Bar.
Autres manuels pour AP6-Pro
1
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels ALTA LABS Point d'accès sans fil
Manuels Point d'accès sans fil populaires d'autres marques
D-Link
D-Link DWL-2100AP - AirPlus Xtreme G Manuel utilisateur
Ubiquiti
Ubiquiti NanoStation NSM2 Manuel utilisateur
Cisco
Cisco Aironet 1550 Series Manuel utilisateur
Aruba
Aruba IAP-335 Manuel utilisateur
Advantek Networks
Advantek Networks AWN-AP-54MR Manuel utilisateur
IP-COM
IP-COM AP355 Manuel utilisateur
