.
Programming the access codes:
This procedure sets the codes used by users for arming/disarming the system. Up to 32 codes
can be programmed. Each must have 4 parameters, including assignment of the zones (A, B, C,
D, E, F) which the code will be able to arm/ disarm
01. Select Access code.
02. Select one of the 32 programmable codes.
03. Touch “Add” and complete the screen as follows: Arm: (specifies the zones the access code
in question will be able to arm). Touch “Arm” and select the zones (A, B, C, D, E, F) you wish to
assign to the code. Confirm with “OK”. Disarm: (specifies the zones the access code in question
will be able to disarm). Touch “Disarm” and select the zones (A, B, C, D, E, F) you wish to assign
to the code. Confirm with “OK”. Anti-duress: (allows you always to disarm an alarm while calling
the emergency numbers. Only use this alarm in case of actual danger). Touch “Anti-duress” and
select “YES” or “NO”. Confirm with “OK”. Name: (associates the code with the name of the user
to whom it is assigned). Touch “Name” and enter the user's name (max. 9 characters). Confirm
with “OK”.
04. Confirm with “OK”. 05. Enter a 5 digit access code; confirm with “OK” (the control panel will
beep to confirm; 3 beeps indicate that the code is already present).
Programming a remote control:
01. Select “Remote controls”.
02. Select one of the 32 programmable remote controls.
03. Touch “Add” and complete the screen as follows: Name: (associates the remote with the
name of the user to whom it is assigned). Touch “Name” and enter the user's name. Confirm
with “OK”. Arm: (specifies the zones to be armed with the remote control being programmed).
Touch “Arm” and select the zones the remote will be able to arm. Confirm with “OK”. Disarm:
(specifies the zones to be disarmed with the remote control being programmed). Touch “Disarm”
and select the zones the remote will be able to disarm. Partial Arm 1: (specifies a part of the
system to be armed with the remote control being programmed). Touch “Partial Arm 1” and
select the zones the remote will be able to arm. Confirm with “OK”. Partial Arm 2: (specifies a
part of the system to be armed with the remote control being programmed). To enable the
second remote control button to control the second partial arming zone, click on the arrow ,
select “Partial Arm 2” and select the zones to assign to the remote. Confirm with “OK”. 04.
Confirm with “OK”.
05. Press “OK” to start acquisition and then press remote control keys “On” and “Off” together.
The control panel will beep to confirm (3 beeps indicate that the remote is already present).
06. Confirm the settings with “OK”.
