MAY/03/2004
750R OP 9
melody sounding from your Remote LCD transceiver and “ ” icon will flashes on the
LCD screen to confirm the remote start was activated.)
3. The engine will start approximately 5 seconds.
4. Once the engine is running, after couple seconds the parking light will turn on again
and climate controls will activate and adjust the vehicles interior temperature to your
preset setting. (While the vehicle is running, the “ ” icon and the “minutes” digit on
the LCD screen will flash and it will indicate count down timer based on the 5, 10, 20
or 30 minute run time set up by your installation center.)
5. The vehicle will run for 5 to 30 minute cycle and automatically shut down. (When the
unit shuts off the count down timer will turn off and the transmitter will play a melody.)
Note: The Remote Start Unit will not start the vehicle if any one of the following
conditions exists:
1. The hood is opened.
2. The brake pedal is pressed.
3. Move the optional remote start enable toggle switch to OFF position. (If installed)
4. The gear selector is in any gear other then “PARK” or “NEUTRAL”
5. Pull down the hand brake. (for Standard Transmission Gear Vehicle)
Engine
Running
SAFE START (Child safety mode)
Factory defaults setting to press the button twice on the transmitter to start the vehicle. Programming
this feature to eliminate an accidental remote start, when kids enter this transmitter, it enquires:
The user presses the transmitter and buttons at the same time to start the vehicle.
B. ENGINE START MEMORIZING FOR THE VEHICLE WITH STANDARD (MANUAL)
TRANSMISSION GEAR (Cut the VIOLET LOOP WIRE for Standard transmission gear vehicle)
The system senses the neutral transmission gear position automatically and there is no prior set-up
required. The system in the standard transmission vehicle operates as following process when you exit the
vehicle to sense and memorize the neutral transmission gear position. If the vehicles are of automatic
transmission gear, this process is omitted.
1. While engine is running by ignition key, pull up the hand brake and place the transmission gear in the
neutral position.
2. Before turning off the engine, press the button twice on the transmitter.
-- The LED indicator will flash 3 times to confirm enter.
3. Pull off the “Ignition Key” from the key cylinder.
-- Engine continues running until the pre-programmed time elapsed or shutdown input is received.--
4. Exit from the vehicle and Close all doors.
-- The engine still continues running and it is normal operating process.--
5. Within 1 minute from the time of step 1, press the button on the transmitter to lock the doors.
6-1. If the engine shuts down immediately and the system is now ready for next remote (or
programmable) engine starts.
6-2. If the engine not shuts down immediately, the system is failed in engine start memorize set up,
repeat above process again.
If the door is opened after above process, the prior memorization for the next remote or programmed
engine start sequence is delete and the function shall not work until you repeat above process again.
Note: If the engine start memorize is set up, the dome light convenience delay function will be temporarily
By-pass.
C. TO OPERATE THE VEHICLE WHILE RUNNING ON THE REMOTE START:
To operate the vehicle while engine running on the remote start.
1. Insert the ignition key and turn it to “ON” (not the start) position.
2. Press the brake pedal.
Note: If the brake pedal is pressed before the key is in the ON position, the engine will shut down.
D. TEMPORARY STOP FEATURE:
This feature allows the vehicle to remain running after the key has been removed from the ignition. This
feature is useful for occasions when you wish to exit and lock the vehicle for short periods of time, but
would like to leave the motor running and the climate control on.
1.Before turning off the engine, press the button twice on the transmitter and the LED indicator will
flash 3 times to confirm enter.
