Albrecht Tectalk Float Manuel utilisateur

Tectalk Float

Manual

English

18 English

Content

Caution.............................................................................................. 19

Scope of Delivery .............................................................................. 20

Installation ......................................................................................... 21

Controls and Indicators...................................................................... 22

LC Display ......................................................................................... 23

Operation .......................................................................................... 24

Additional Functions .......................................................................... 25

Troubleshooting................................................................................. 29

Warranty and Recycling Information.................................................. 31

Technical Specifications .................................................................... 32

English 19

Caution

IMPORTANT - READ ALL INSTRUCTIONS carefully and completely

before operating your radio and retain this manual for future reference.

NEVER connect the radio to a power source other than the supplied

battery pack. This may damage your product.

NEVER operate your radio with the antenna less than 5 cm from

exposed parts of the body.

NEVER use the radio in or near a mining facility or other area which

uses remotely triggered explosives or an area labeled "Blasting Area".

NEVER use or charge your radio in a potentially explosive atmosphere.

DO NOT place your radio in front of a vehicle airbag.

DO NOT operate your radio on board of an aircraft.

DO NOT use your radio with a damaged antenna.

DO NOT attempt to modify your radio in any way.

ALWAYS charge your radio at normal room temperature.

ALWAYS switch off your radio where notices restrict the use of two-

way radio or mobile telephones.

ALWAYS replace the accessory jack cover when the jack is not in use.

ONLY use ALBRECHT approved rechargeable batteries with the

supplied charger.

AVOID charging your radio or battery pack while is it wet.

AVOID storing or charging your radio in direct sunlight.

AVOID storing or using your radio where temperatures are below

-20℃or above +60℃

Please observe the country information on the gift box and on our

internet server service.alan-electronics.de.

20 English

Scope of Delivery

•Belt Clip

•Adapter for ALBRECHT headsets

•Tectalk Float Radio with Antenna

•Li-Ion battery pack

•Desktop charger

•Power adaptor

English 21

Installation

1 Removing the belt clip

a. Pull the belt clip latch

away from the unit

b. While pulling the belt

clip latch, push up the

belt clip as shown in Figure 1

2 Installing the belt clip Figure1 Figure2

a. Slide the belt clip into the

slot as shown in Figure 2

b. A “click” indicates the belt clip

Is locked into position

3 Installing the supplied Li-ion rechargeable battery

a. Unscrew the screw and then

remove the battery door.

b. Insert the battery connector into

the socket located inside the

battery compartment and install

the battery pack.

c. Re-install the battery door and

tighten the screw

4. Charging the rechargeable battery pack

It is recommended to turning OFF the unit while charging.

Charge the Battery pack 10-14 hrs. prior to initial use.

When the battery capacity is low, the bA Lo indication

and the battery status icon will flash on the LC

Display. Recharge the battery pack at this time,

please refer to the following item "BATTERY

CHARGING".

22 English

Controls and Indicators

1. High efficiency antenna

2. Belt Clip

3. Battery door

4. PTT (Push-To-Talk) button

5. Lamp/Monitor button

6. External earset-microphone jack

7. Key Lock button

8. Channel UP button

9. Channel DOWN button

10. Built-in Microphone

11. Backlighted LC Display

12. ON-OFF button

13. Call Tone button

14. Volume UP button

15. Volume DOWN button

16. Menu button

17. Built-in Speaker

English 23

LC Display

A. Keypad LOCK icon - is lighted when buttons are locked.

B. TX icon - is lighted on when the radio is in transmit mode.

C. RX icon - is lighted on when the radio is in receive mode.

D. DW icon - Dual Watch function

E. Scan icon - Automatic channels or CTCSS code scanning

F. LO icon - Transmitter Low Power icon

G. Keypad Beep Tone icon

H. VOX (hands-free use) icon

I. CTCSS Code number(1-38)

J. Selected Channel Indication (1-8)

K. Stop Watch function icon

L. Power save function icon

M. Roger Beep function icon

N. Battery Status Indicator

24 English

Operation

Power ON-OFF

1. To turn on the unit, press and hold the ON-OFF button, the LC

Display will show the channel number and the CTCSS code

number.

2. To turn off the unit, press and hold again the ON-OFF button.

Using the radio

The unit has 8 main channels and 38 CTCSS codes for each

channel. You can communicate with any other radios that are using the

same main channel & CTCSS code.

Speaking to other radios

1. Press and hold the PTT button, the TX icon will be shown in the

LC Display.

2. Hold the unit in a vertical position with the microphone

at 5-8 cm from the mouth and then speak.

3. When you have finished speaking, release the PTT button.

4. Now you are ready to receive incoming signals. Adjust the

volume to the desired level if necessary.

Time-out Timer (TOT)

The Time-out Timer disables transmitting after 3 minutes maximum

transmission period. Transmitting can only be reactivated by releasing

and pressing the PTT button again.

Using a Headset

1. Connect the headset to the jack on top of the device.

(to connect accessory with a 2.5 mm stereo plug use the

supplied adapter)

2. Press the PTT button on the earphone to speak and release it

to listen.

3. Adjust the volume if necessary.

Please note that the degree of protection IPX7 only applies if the

headset jack is sealed with the rubber stopper.

English 25

Channel Selection

Press the CH UP or CH DOWN to select the desired channel (1-8).

The factory default start up channel is channel 1 and sub-channel 00.

Before selecting a channel for communication, always listen on it to

ensure it is not already being used. Always avoid selecting a busy

channel when the unit keeps on receiving signal from unknown parties.

Volume selection (8 Levels)

1. Press the VOL UP to increase the volume.

2. Press the VOL DOWN to decrease the volume.

The LE icon and the selected volume level (01-08) will appear on the

LC Display.

Additional Functions

Menu Operation

Press MENU button to successively select these functions.

Press the CH UP or CH DOWN buttons to select the desired

setting for the selected menu item. If you press and hold the CH UP or

CH DOWN buttons, the selection will move quicker.

Normal

Operation

CTCSS

TX Power

VOX on/off

VOX

Sensitivity

Scan

CTCSS

Scan

Dual Watch

Call Tone

Roger Beep

Keytone

Stop Watch

26 English

To confirm the selection and exit the Menu mode, press the

LOCK button or MENU button to move to the next function.

CTCSS Code Selection

The radio has 38 CTCSS private codes available. Different CTCSS

tones may be associated to different channels. Selecting a CTCSS

code of 00 will disable the CTCSS feature. To communicate between

two or more radios, both the channel and CTCSS code selections must

be the same. To communicate with other models and brands of radios,

the actual radio frequency and CTCSS frequency must be matched.

The frequency chart and CTCSS code chart are included to help with

this selection.

Transmitter RF Power Setting

Your radio has a HI/LO Power selection function. This function

is very convenient to reduce the current drain and extend

battery life when communicating within short distance.

VOX Function

Your radio is equipped with a user selectable Voice Operated

Transmitter function (VOX), that is used for automatic voice

transmission (hands-free use or baby room monitor use). In this mode,

transmission is automatically initiated by speaking into the microphone

and there is no need to push the PTT button (hands-free use or baby

room monitor use). You can plug in the earset-microphone for hands-

free talking and listening. When VOX feature is on, the VOX icon will

appear on the LC Display.

VOX Sensitivity Level Selection

The sensitivity, at which speech level the device begins to transmit is

adjustable in five steps. The VOX level 05 indicates the highest VOX

sensitivity.

Channel Scanning

The direction of scanning can be determined by pressing the

CH UP or CH DOWN buttons. If you press the PTT or LOCK button

during the SCAN operation, SCAN will stop automatically and radio will

Autres manuels pour Tectalk Float

Table des matières

Autres manuels Albrecht Récepteur

Albrecht

Albrecht AE 86 H Manuel utilisateur

Albrecht

Albrecht AE125H Manuel utilisateur

Albrecht

Albrecht AE 500 H First Edition Manuel utilisateur

Albrecht

Albrecht ATR 400 Manuel utilisateur

Albrecht

Albrecht AE 92 H Manuel utilisateur

Albrecht

Albrecht DR 500 Manuel utilisateur

Albrecht

Albrecht AE75H Manuel utilisateur

Albrecht

Albrecht AE 600 H Manuel utilisateur

Albrecht

Albrecht DR 70 Manuel utilisateur

Albrecht

Albrecht AE69-2H Manuel utilisateur

Albrecht

Albrecht AIRCONTROL 9000 Manuel utilisateur

Albrecht

Albrecht AE 600 H Manuel utilisateur

Albrecht

Albrecht AE 65 H Manuel utilisateur

Albrecht

Albrecht AE 230 H Manuel utilisateur

Albrecht

Albrecht ATR 200 Manuel utilisateur

Albrecht

Albrecht TELME Series Manuel utilisateur

Albrecht

Albrecht AE30H Manuel utilisateur

Albrecht

Albrecht PR-446 Manuel utilisateur

Albrecht

Albrecht AE 69 H Manuel utilisateur

Albrecht

Albrecht AE 82 H BT Manuel utilisateur

Albrecht

Albrecht DR 403 Guide de l'utilisateur

Albrecht

Albrecht 4032661271259 Manuel utilisateur

Albrecht

Albrecht AE 72 H Manuel utilisateur

Manuels Récepteur populaires d'autres marques

Garmin

Garmin GA 23 Manuel utilisateur

Aiphone

Aiphone PS-12F Manuel utilisateur

IMES

IMES TCS-01CA-PMI Manuel utilisateur

BWI Eagle

BWI Eagle AIR-EAGLE SR Manuel

AMIMON

AMIMON AMN12310 WHDI Manuel utilisateur

Dual

Dual DMCPA79BT Mode d'emploi

Sound Associates

Sound Associates SA652P Manuel utilisateur

Sherwood

Sherwood NewCastle R-772 Manuel utilisateur

Audio

Audio A10-RX Series Manuel utilisateur

AllSee

AllSee PushShare PSRV1.1 Manuel utilisateur

DEMAG

DEMAG DRC-DR D2 Manuel utilisateur

Teleco

Teleco TVRCL868A02 Manuel utilisateur

Bosch

Bosch RF3222E Manuel utilisateur

Kramer

Kramer 631R Manuel utilisateur

Xpress

Xpress xmc10 Manuel utilisateur

JVC

JVC KD-MR1BTS Manuel utilisateur

Omega Engineering

Omega Engineering UWTC-REC3 Manuel utilisateur

e-survey

e-survey E300 Pro Manuel utilisateur