Akuvox E21 Series Manuel utilisateur

E21A/E21V x 1

Torx wrench x 1

M4x15 Torx head screw x 4

Flush-mounting box x 1（Optional）

E21X

Before you begin using the device, please check the version you got and ensure that the following

items are included in the shipped box:

Sensor

Status LED

Mic

According to the position of

the cable, cut a square hole

in the wall of the height of

190mm，width of 100 and

depth of 60 mm that can

accommodate and through

out all necessary cables.

Knock out suitable cable

holes of the flush-mounting

box,then insert the

flush-mounting box into the

square hole on the wall and

route through all cables.

Use cement or non-corrosive

structural adhesives to fill the

gap between the wall and

flush-mounting box.Wait the

adhesive material dry, go to

the next step.

Fix E21X on the flush-mounting

box with four M4x15 Torx

head screws.

Device Wiring

Wire Length & AWG Table

Please follow the properly measured wire gauge/length to install device:

16 AWG 18 AWG 20 AWG 24 AWG

12V 1A Adapter ≤50m ≤50m ≤50m

Note: If power device with POE,

please do not plug in another

power supply.

22 AWG

≤40m ≤20m

E21X

1. Access the Web UI: Input the IP address into browser to configure the phone.

2. Account Registration: On web UI, go to the path: Account > Basic to register an account

and fill in the account information. ( Please refer to admin guide for

more information)

3. Push Button Configuration: On web UI, go to the path: Intercom > Basic > Push Button

to configure the call number.

4. DTMF code Configuration: On web UI, go to the path: Intercom > Relay > Relay

ID/DTMF and choose the DTMF code number in corresponding area.

IP Announcement

1.While E21X starts up normally, hold the Call Button for several seconds after Status LED

light turns blue, the voice system will enter IP announcement mode.

2.In announcement mode, the IP address will be announced periodically.

3.Press Call Button again to exit the announcement mode.

* If no IP address has been obtained, E21X announces “IP 0.0.0.0”.

E21X

Note: For more LED settings, please check in Intercom > LED Setting of E21 Web UI.

Make a call:

1. Press the Call Button to call indoor SIP Phone, video call is only for E21V.

2. During the talk, a called party can press predeﬁned DTMF code number to open

the door.

Receive a call:

E21X supports Auto Answer by default. Incoming calls will be answered automatically.

AKUVOX (XIAMEN) NETWORKS CO., LTD.

Add.: 10/F, NO.56 GUANRI ROAD, SOFTWARE PARK II, XIAMEN 361009, CHINA

www.akuvox.com

Notice Information

Akuvox E21X firmware contains third-party open source software under the terms of the GNU General Public

License(GPL). Akuvox is committed to meeting the requirements of the GNU General Public License (GPL) and will

make all required source code available.

The source code of software under the terms of GNU GPL can be downloaded online: http://www.akuvox.com/gpl.

Information contained in this document is believed to be accurate and reliable at the time of printing. This document is

subject to change without notice, any update to this document can be viewed on Akuvox’ s website:

Autres manuels pour E21 Series

Ce manuel convient aux modèles suivants

Autres manuels Akuvox Système d'interphone

Akuvox

Akuvox E16 Series Manuel de service

Akuvox

Akuvox A05 Series Manuel de service

Akuvox

Akuvox C313 Series Manuel utilisateur

Akuvox

Akuvox X912 Manuel utilisateur

Akuvox

Akuvox R26P Manuel

Akuvox

Akuvox R29 Series Manuel de service

Akuvox

Akuvox C313X Manuel utilisateur

Akuvox

Akuvox R26 Manuel utilisateur

Akuvox

Akuvox IT88 Series Manuel

Akuvox

Akuvox R26 Manuel utilisateur

Akuvox

Akuvox R20B Series Manuel

Akuvox

Akuvox IT82 Series Manuel utilisateur

Akuvox

Akuvox R20AS Manuel utilisateur

Akuvox

Akuvox R26B Manuel utilisateur

Akuvox

Akuvox R23C Manuel utilisateur

Akuvox

Akuvox E12 Manuel utilisateur

Akuvox

Akuvox C317A Manuel utilisateur

Akuvox

Akuvox E10S Manuel utilisateur

Akuvox

Akuvox R20A Manuel utilisateur

Akuvox

Akuvox X915 Series Manuel de service

Akuvox

Akuvox IT82A Manuel

Akuvox

Akuvox IT81 Manuel utilisateur

Akuvox

Akuvox R29 Series Manuel utilisateur

Akuvox

Akuvox X916 series Manuel utilisateur

Manuels Système d'interphone populaires d'autres marques

Bticino

Bticino LINEA 3000 Manuel utilisateur

MSI

MSI MSI-140 Manuel utilisateur

golmar

golmar Stadio Plus Manuel utilisateur

CyberData

CyberData 011211 series Manuel

Vidos

Vidos duo M1021 Manuel utilisateur

Vimar

Vimar ELVOX 7539/E Manuel utilisateur

SSS Siedle

SSS Siedle BTSV 850-03 Manuel utilisateur

Dahua

Dahua VTO Series Manuel utilisateur

Elvox

Elvox 5651 Manuel utilisateur

Videx

Videx VIDEOKIT Series Manuel utilisateur

Rocom

Rocom Doortello Business FW T2.05W2.04 Manuel utilisateur

Viking

Viking E-35-EWP Manuel utilisateur

Safeguard Supply

Safeguard Supply LRA-EX1000 Manuel utilisateur

SSS Siedle

SSS Siedle BFCV 850 Series Manuel utilisateur

GRD

GRD MAX V2 Manuel utilisateur

Alecto

Alecto ADI-250 Manuel utilisateur

Aiphone

Aiphone IE-8MD Manuel utilisateur

Perel

Perel EDB4 Manuel utilisateur