Aicok BG525 Manuel utilisateur
GARMENT STEAMER
Model No: BG525
- HOUSEHOLD USE ONLY -
INSTRUCTION MANUAL
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE
IMPORTANT SAFETY
INSTRUCTIONS
1. When using your appliance, basic precauons should always be followed,
including the following:
2. Read all instrucons before use.
3. Use appliance for its intended use only.
4. This product has been designed for domesc use only. Any commercial
use, inappropriate use or failure to comply with the instrucons, the
manufacturer accepts no responsibility and the guarantee will not apply.
5. This appliance is not designed to be used by people (including children)
with a physical, sensory or mental impairment, or people without
knowledge or experience, unless they are supervised or given prior
instrucons concerning the use of the appliance by someone responsible
for their safety.
6. Children must be supervised to ensure that they do not play with the
appliance.
7. Do not leave appliance unaended while plugged in or while it is sll hot.
8. Do not operate any appliance with a damaged cord, plug or steam hose
or aer the appliance malfuncons, or is dropped or damaged in any
manner.
9. To reduce the risk of electric shock, do not disassemble or aempt to
repair the appliance.
10. Return appliance to nearest authorized service center for examinaon,
repair or adjustment.
11. To reduce the risk of contact with hot water eming from steam vents,
check appliance before each use by holding it away from your body and
operang.
12. Steam only in an up and down vercal moon.
13. Never use steam head in a horizontal posion or lt into a backward
posion, this may result in water discharge.
14. To reduce the risk of electric shock, do not immerse the appliance in
water or other liquids. Appliance should always be turned off before
plugging or unplugging.
15. Never pull on the cord to unplug from outlet, instead grasp plug and pull
to unplug.
16. Do not allow cord to touch hot surfaces. Let appliance cool completely
- 1 -
before pung away.
17. Loop cord loosely under the appliance when storing.
18. Do not let power cord contact sharp edges or hot surfaces. Do not try to
fasten the hose adapter during operaon. Scalding may occur if the hose
adapter is removed while using the appliance.
19. Always unplug appliance from an electrical outlet when filling with water,
emptying or when not in use.
20. Do not aempt to hang up the unit using the hose.
21. The use of foreign accessory aachments that are not supplied by Cory
is not recommended and may result in fire, electric shock or personal
injury. Burns could occur from touching hot parts, hot water or steam.
Use care when you empty a steam appliance. There may be hot water
in the reservoir.
22. Do not direct steam at people, animals or steam clothes while they are
being worn.
23. Your Aicok appliance is intended for household use only. This is a floor
appliance never carry it while in use.
SPECIAL INSTRUCTIONS
24. This is a 1500 wa appliance. To avoid a circuit overload, do not
operate a high waage appliance on the same circuit.
25. If an extension cord is absolutely necessary, the marked electrical rang
should be at least as great as the electrical rang of the appliance. Cords
rated for less amperage may overheat. Care should be taken to arrange
the cord so that it cannot be pulled or tripped over.
26. Do not cut or aempt to extend the steaming hose.
Environment protection first !
Your appliance contains valuable materials which can be recovered or
recycled.
Leave it at a civic waste disposal centre.
- 2 -
Product Descripon:
A：Steam brush
B：Bracket head
C：Hanger
D：Handle
E：Up and down pole
F：Buckle
G：Steam tube
H：Bracket pole set
I：Steam tube head
J：Tank
K：Power indicator lamp
L：Knob switch
M：Wheel
N：Drain hole
1. Installaon（Before use ）
· Pls read the instrucon carefully.
· Remove all the package.
· Do not power on or open before finish the install.
· Appliance knock down assembly picture.
· Put the telescopic pole insert the base. Fig. 1
· Make sure the knob ght aer insert the body.
· Open the telescopic buckle, pull the Aluminum pole. Fig .2 And keep
the buckle ght.
· Open the hanger and put it on the top of the pole. Fig .3 Tighten the
hickey up.
· Put the steam tube e-in insert the hole. Fig.4. Put the steam brush
on the brush fix base.
2．Iron instrucon
· Open the cover of water tank , fill the water into water tank. Fig.5
- 3 -
· Do not fill hot water.
· Close the water tank cover, put the water tank on the body.
· Light place the water tank to prevent the collision.
· Pull the power cord, socket on. Turn the knob on chemical fiber Fig. 6,
And the indicator lamp will be light. If you want larger steam to ironing
thick cloth, please turn the knob on coon and linen posion. When
finishing the ironing work, first turn the knob on off posion, and then
pull telescopic buckle.
· During operate, steam tube will be some sound of water flow, this is
normal. When heard this sound, pull the tube upside, made the bead
back to boiler.
· In order to extend the appliance life, aer operang, dump the water
inside the water tank, make the appliance dry working 5 minutes, make
the boiler dry, power off when without steam .
1
65
9 10 11
7 8
2 3 4
- 4 -
Remind: When use the accessories, only can use at vercal direcon, please
don’t iron at horizon direcon.
· Before using the accessories, please read the instrucon manual, first use,
suggest test with some old or waste cloth.
Brush fig.7
· Use brush can make the steam infiltrate cloth, make good iron effect.
· Remind: install brush make the steam brush cool.
·
When install brush, make steam brush panel upside, push brush accessories
gently, make the buckle ghtly.
· When ironing, should be from top to end.
·
Before remove the brush, please power off the power control switch, when
there is no steam from the steam brush, remove the brush, please note
do not touch the stainless steal panel, avoid scald hand.
Iron splint fig.8 fig.9 fig. 10 fig.11
· Splint can help iron hem and cockle easily.
· Install the splint on the steam brush, push it ghtly to its posion.
· Hold the steam brush, open the splint.
· Put the cloth between splint and steam brush.
· Release handle, made it clamp cloth, ironing from upside to downside.
Before remove splint, please power off the power control switch, when
there is no steam from the steam brush, remove the brush, please note
do not touch the stainless steal panel, avoid scald hand.
·
· Aer using, remove the water tank from the body, dump the water in the
water tank.
· Make the appliance dry working 5 minutes. Make the boiler dry.
· Power off the power switch,(power indicate lame will be off),remove the
power cord, press the cord rewind buon, rewind the power cord into the
body.
3． Accessories instrucon
4. Storage
- 5 -
· Warning: pls do not touch the steam brush before it cooling, make the
boiler dry before storage.
·
Please use a wet rag clean the body. In order to make your product always
have a good capability, clean the scale unming, the period depend on
the using period. Water tank at least once per year, or once per 100 hours.
· The process for clean the scale is as below:
① Remove the water tank, wash the scale at water base with clean water.
② Open the water tank base knob, dump mixture in the water tank, wash
with clean water.
·
Aer clean the scale, if you think there is sll scale, please repeat the above
process.
5. Cleaning
·
Please don’t use the other accessories without permission of the manufacture.
Or else, the guarantee will become invalid to the stoppage caused by this acon.
·
Please check up if the product is destroyed or the accessories are all ready.
·
Child or the disabled should use the product with the care of their guardian.
·
If the machine breakdown or other dangerous accident happens, please pull
out telescopic pole at once. Remember that don’t place the bad machine
working.
·
The destroyed power line should be sent to the manufacture or the professional
worker to change.
Behaviours with this marker showed in the following pictures are not allowed.
Or else, it will bring some damages to the product or dangers to the user.
When you see this marker, that is, the operaon should act according to the
picture showing strictly. Or else, it will bring some damages to the product or
dangers to the user.
Maers with this marker should be paid more aenons to. Or else, it will bring
some damages to the product because of the improper operaon or other loss.
6. Maers need aenon
BAN
WARNING
NOTICE
- 6 -
- 7 -
- 8 -
·
Rated voltage：AC 120V. Output steam temperature：210℉
·
Rated frequency： 60Hz Max length of lever：1.27m
·
Output power：1500W Steam pipe length：1.7m
·
Capacity：55Oz
·
Connued steam me：60min
·
Steam flow：30g/min
6. Maers need aenon
8. Parameter:
Problem
The security device does
not work.
One of the circuits has fault,
the
plug is loose, the fuse
burned, the
LED of supply
source is exnguished.
Check and maintain by
specialized technician
A noise originates pipe of
steam but the produced
steam is weak.
The pipe is twisted below
level to iron.
Raise the steam pipe
(residual water in top
returns into the device).
Spray head is leaked The head is broken, or the
ironing is vercal.
Replace the spray head.
Move from top down
to operate.
Hooking connecon of
steam pipe is leaked.
The cushion can be damaged
itself with the aging, the juncon
interface loosen itself.
Replace the cushion. Rotate
the juncon of steam pipe
ghtly.
Water spilled out water
tank
Water tank is broken or has a
hole Replace the water tank
Steam is weak
The power source is lower or
deposits can obstruct the
arrival pipe.
Add a stabilizer of power
source. Use a cleaning
respecng the environment.
Water tank is in distoron
Over heated water is put.
Or other chemical element
is put
Connue to use.
Replace the water tank
No steam but the indicator
is lighted
The steam creator is broken.
The internal electric
component is broken.
Call a specialized technician
to do an examinaon
Cause Soluon
- 9 -
Table des matières
Autres manuels Aicok Nettoyeur à vapeur
