3
Adventure Kings King Wing
FITTING INSTRUCTIONS
Please read the following instructions which include three of the most common methods for fitting
the King Wing to your vehicle. It is the owner’s responsibility to ensure that the awning is securely
fastened and safe for use as well as vehicle travel. It is important when mounting the awning
to ensure that all the mounting brackets supplied are spaced far enough apart to adequately
support the weight of the awning. When you are positioning the awning check that there is
enough clearance for the vehicle doors to open. Remember to check vehicle roof and roof rack load
capacities prior to fitting accessories to your vehicle. Take into account when mounting vehicle roof
accessories that off-road travel increases the dynamic stresses on your vehicle. For more information
on load carrying capacities contact the applicable manufacturer.
OPTION 1: MOUNTING DIRECTLY TO A ROOF RACK
1. Slide the bolts supplied in the awning kit into the top and
bottom t-slots on the mounting rail using the central
clearance hole. See Figure 1.
2. With assistance from another person hold the awning in
the desired position and mark the mounting holes in the
roof rack. Check that the vehicle doors can be opened and
closed. The mounting holes in the roof rack plates should be
vertically spaced 33mm apart to suit the awning backing
plate. Fit as many of the supplied bolts as possible.
3. Ensuring that the hole marks are vertically spaced 33mm
apart then using a centre punch, centre mark each hole.
4. Once centre marked, drill out the holes to suit supplied bolts.
Use correct PPE when operating power tools. See Figure 2.
5. Align the awning in the desired position and guide bolts
through roof rack mounting holes. Tighten the supplied nuts
to secure awning. See Figure 3.
6. Regularly recheck the nuts and bolts to ensure they are tight
and in good condition.
Figure 1
Figure 2
Figure 3
