Advent ADV10PS2 Manuel utilisateur
OPERATION
MANUAL
ADV10PS2
10.2" OVERHEAD LCD
MONITOR WITH
SONY PS2 PLAYER
128-8669
R
MENU/ ENTER
Important Notice
Installation of overhead products requires careful planning and preparation. Be extremely careful when working on a vehicle with side
curtain air bags. Do not route wires near any portion of the side curtain air bag assemblies. This includes any anchor points in A, B, C or
D pillars of the vehicle. Routing wires in these areas or running wires by the side curtain air bags can prevent the side curtain air bag from
fully deploying which can result in personal injury to vehicle occupants. If you have any questions regarding wire routing in a vehicle,
please contact Audiovox Technical Support at 1-800-225-6074.
When connecting power and ground in a mobile video installation ensure that the ACC wire is fused at the point where it is connected to
the vehicle ACC wiring. Failure to do so can result in damage to the vehicle if a short circuit develops between the vehicle connection
point and the mobile video product.
An LCD panel and/or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is used
for vehicle information, system control, rear or side observation or navigation. If the LCD panel or video monitor is used for television
reception, video or DVD play, the LCD panel or video monitor must be installed so that these features will only function when the vehicle is
in “park” or when the vehicle's parking brake is applied.
An LCD panel or video monitor used for television reception, video or DVD play that operates when the vehicle is in gear or when the
parking brake is not applied must be installed to the rear of the driver's seat where it will not be visible, directly or indirectly, to the operator
of the motor vehicle.
Licensed under one or more of the following patents,
Patent NOS. 5,775,762 and 5,927,784
Warnings
•Do not use any solvents or cleaning materials when cleaning the video monitor.
•Do not use any abrasive cleaners, they may scratch the screen.
•Use only a lightly dampened lint free cloth to wipe the screen if it is dirty.
•Lock the LCD screen in the fully closed position when not in use.
•Before putting on headphones always adjust the volume setting to the lowest position.
•Remember to leave the dome light switch in the off or auto positions when the vehicle is unattended, as the dome lights, if left on, can drain
the vehicle's battery.
•Do not put pressure on the screen.
•Caution children to avoid touching or scratching the screen, as it may become dirty or damaged.
3
FEATURES
Congratulations
Congratulations on your purchase of the ADVENT
ADV10PS2 Player with Drop-Down Video / Monitor. The
ADV10PS2 has been designed to give you and your family
many years of video entertainment in the mobile
environment. Please read the directions that follow to
familiarize yourself with the product to ensure that you obtain
the best results from your equipment.
Please note: Installation options vary, see the individual
owner's manuals for each component in your system to
obtain a full understanding of each component's operation.
Safety Precaution
For safety reasons, when changing video media it is
recommended that the vehicle is not in motion, and that you
do not allow children to unfasten seat-belts to change video
media or make any adjustments to the system. System
adjustments can be accomplished using the remote control,
while seat-belts remain fastened. Enjoy your ADVENT
entertainment system but remember the safety of all
passengers remains the number one priority.
• 10.2” TFT (Thin Film Transistor) Active Matrix LCD
(Liquid Crystal Display) Monitor
•Built-in SONY PS2 Player
• OSD (On Screen Display) for Control of Picture Quality
and Functions
•
•Four Audio/Video Source Inputs (AV1, AUX, PS2).
• Dome Lights with 3-Position Switch.
•Built-in 16 Channel Frequency Wireless FM Modulator.
•
• SONY PS2
•
•
•
•Playing DVD, CD and SONY PS2 Games.
Single Channel Infrared Transmitter for IR Wireless
Headphones
AV Output Via RCA Pigtail
Screen Mode Selection (4:3, 16:9)
Wireless Game Controller
Full Function Remote Control
Backlit Controls
4
CONTROLS AND INDICATORS DIAGRAM (FRONT VIEW)
1. SOURCE Button (S)
Use to select the sources:AV1,AUX and PS2.
2. CURSOR Button (pqtu)
Use these buttons to access menu selections on the screen.
3. MENU/ENTER Button
Use these buttons to access SYSTEM MENU.
4. Infrared Transmitter and Sensor
Transmits audio to wireless headphones, allows the remote
control to operate the unit and to control other accessories in the
system.
5. POWER Button ( )
Used to turn the system on/off (standby).
6. Dome Lights
Provide additional interior illumination.
7. Three Position Dome Light Switch
ON - Turns on the dome lights.
OFF - The dome lights will not turn on in this position.
AUTO - Automatically switches on the dome lights in
Conjunction with the vehicle's interior illumination.
8. PS2 CONSOLE
9. MEMORY CARD SLOT 1 & MEMORY CARD 2
10. PS2 WIRELESS FORCE 2 CONTROLLER
MEM ORY CARD MEM ORY CARD RESE T I /
MENU / ENTER
FORCE LINK
1234567
8
12
11
9
10
13
15
16
14
FORCE LINK
5
11. LCD Panel
12. Screen Release
Press to release the screen.
13. LCD Cut Off Switch
Used to turn off the LCD backlit when the LCD is in the closed
position.
14. OPEN
Push to open the PS2 tray.
15. OPEN ()
The disc tray opens.
16. RESET ( )
ON/Standby and RESET indicator.
CONTROL FUNCTION DESCRIPTION
(SIDE VIEW)
1. HEADPHONE JACK
The jack is applicable for wired headphone with a 1/8”
(3.5mm) plug to listen audio output.
2. Auxiliary Audio Right Input
3. Auxiliary Audio Left Input
4. Auxiliary Video Input
VIDEOAUDIO L
R
1 2 3 4
6
MAIN FUNCTION OPERATIONREMOTE CONTROL OPERATION
Battery Installation
Before attempting to operate your Remote Control, install the
batteries as described below.
1) Turn the Remote Control face down. Using your finger, slide
the battery cover off in the direction of the arrow.
2) Install Two “AAA” batteries. Make sure that proper polarity
(+ or -) is observed.
3) Align the cover tabs with the remote control and slide the
cover until it locks.
The remote control will operate the unit. It is not a universal remote
control and will not control equipment from other
manufacturers.
Back View
Battery Cover
OPEN/
CLOSE
AUDIO SHUFFLE
1
4
2
5
3
6
78 9
ANGLE PROGRAM
SUBTITLE REPEAT
CLEAR
SLOW
SCAN PREV NEXT A-B
RESET
DISPLAY TOP MENU MENU RETURN
PAUSE STOPPLAY
ENTER
STARTSELECT
R1
L1 L3 R3
L2 R2
ENTER
SOURCE
MUTE DISPLAY
FMM ON/OFF
FMM SELECT SYSTEM
MENU
IR ON/OFF
PIX
VOLUME
0
TIME
DVD /PLAYSTATION
P1
P2
P3
P4
P5
P6
P8
P9
P7
P10
P11
P12
P13
P15
P14
P16
P17
P18
P19
P20
M1
M2
M3
M4
M5
M6
P37
M7
M8
M9
M10
M11
P22
P23
P25
P24
P26
P27
P28
P29
P30
P31
P32
P33
P34
P35
P36
7
*P1 ~ P37: SONY PS2 console (refer the SONY PS2 manual for detail).
* M1~ M11: Overhead LCD Monitor.
P1. OPEN / CLOSE
To open and close the disc tray.
P2. AUDIO
Displays and changes audio options on DVDs with multiple audio tracks.
P3. SHUFFLE
Begins playback of titles or chapters in a random order.
P4. ANGLE
Display and changes viewing angles on DVDs recorded with multi-angle options.
P5. PROGRAM
Begins playback of titles or chapters in a programmed sequence.
P6. SUBTITLE
Displays and changes subtitle options on DVDs with subtitle options.
P7. REPEAT
Selects repeated playback of all the titles on the disc, or one title or one chapter.
P8. SLOW ( / )
Changes to playback/reverse playback in slow-motion.
P9. SCAN ( / )
Fast reverse / forwards playback.
8
P10. PLAY
Starts playback.
P11. DISPLAY
Display the control panel.
P12. TOP MENU
Display the DVD-Video menu.
P13. BUTTON: DVD MENU
Select the item want to change.
P14. ENTER
Used to implement a selected setting or menu option.
P15. BUTTON: TITLE MENU
Select the title want to play.
P16. DIRECTIONAL BUTTONS: CURSOR CONTROL
Use these buttons to access menu selection on the screen.
P17. L3 BUTTON
Display Subtitle Options, to select the subtitle language, and turn it on or off.
P18. L1 BUTTON
Previous (9), press to return to the previous chapter or track.
P19. L2 BUTTON
Search ( ), fast reverse forwards playback.
9
P20. SELECT
Display the control panel.
P21 START
Play / Pause.
P22. R2 BUTTON
Search ( ), forwards playback
P23. R1 BUTTON
Next (:), press to skip to the next chapter or track.
P24. R3 BUTTON
Display Audio Options, press the language changes.
P25. BUTTON: ENTER
P26. BUTTON: CANCEL /<(Stop)
P27. MENU
Display the DVD-Video Menu.
P28. RETURN
Returns to the previously selected screen within the DVD’s menu.
P29. PAUSE
Pauses playback.
P30. STOP
Stop playback. Selecting <(stop) again after playback is stopped clears resume play (playback from the last stopping point).
P31. PREVIOUS(9) / NEXT (:)
Return/skips to the beginning of the current, previous or next chapter.
P32. A-B REPEAT
Specifies a scene for playback, and starts playback of the scene that has been set.
P33. CLEAR
Clears selected numbers or playback modes.
P34. TIME
Display the current title or chapter number, the elapsed time, etc.
P35. NUMBER 0~9
Used to the enter the number of a chapter.
P36 STANDBY / RESET
Turn the Power On/OFF
M1. POWER
Press this button to turn the unit ON and OFF.
M2. MUTE
Press this button to mute the audio.
Pressing the button again restores the sound to the previously set level.
M3. FMM ON/OFF
Turns the wireless FM Modulator ON or OFF.
M4 FMM SELECT
Select the FM Modulator Frequency.
10
Autres manuels pour ADV10PS2
2
Table des matières
Autres manuels Advent Moniteur
