ADVATUM allure Manuel utilisateur
I N S T R U C T I O N S
Assemble pole.
1
Assemble the Stand
Insert bottom and lock connector by rotating
handle clockwise and pushing handle down.
3
Insert top by sliding tapered end into top of pole
and push flush.
4
Find bottom and top of graphic and pole.
2
Verify the graphic is not twisted and that the graphic
covers the corners.
Important:
Note: The directions are the same for each shape.
Top
Bottom
(without connector)
(with connector)
Top
(with light hole)
Bottom
(without hole)
5
Adjust lean to make vertical.
-After prolonged periods of storage, the graphic may have wrinkles.
To eliminate the wrinkles leave the stand set-up for several hours or use a steamer.*
*A Micro Steamer option is available.
Helpful Tip: It’s easier to make the top connection
if the stand is held at waist level rather then if your
hands are held up over your head.
www.AdvatumDisplays.com
I N S T R U C T I O N S
Connect the Shelf
Connect the Stand Off Graphic
Attach shelf. (Tube with hole)
-The higher the shelf is positioned, the more likely it is to
touch the side of the graphic.
-To avoid damaging the acrylic shelf when disassembling
the stand, be sure to detach the shelf from the utility bar
before removing the utility bar from the stand.
Attach stand off graphic to utility bar with Velcro strip.
2
Attach support base.* (Tube without hole)
*Left Slope, Right Slope, and Fountain only
1 2
Attach utility bar to main pole.*
1
- Utility bar can be placed anywhere
between 20”h and 46”h.
- The lower the stand off graphic is positioned,
the closer it
will be to the main graphic.
- Guarantee excludes scratching or breaking of acrylic shelf.
Shelf Placement*
Left Slope 30”h to 46”h
Right Slope 30”h to 46”h
Fountain 30”h to 46”h
Bow 36”h (not adjustable)
*Shelf and base can connect from either side
-To improve the strength of the shelf and base tube
tighten the connector clamps.
Weight Limit
-12 lbs. max per shelf
-20 lbs. combined total
for multiple shelves
*Can connect from either side
