Adexa CV4540 Manuel utilisateur
CV4540 VACUUM SEALER
INSTRUCTIONS
IMPORTANT SAFEGUARDS
When using this electrical appliance, safety precautions
should always be observed, including the following:
READ ALL INSTRUCTIONS
1. Carefully read all of the instructions before using this appliance and
save for future reference.
2. Before plugging cord into wall outlet, or disconnecting, make sure
that the cover of the machine is in unlocked condition, and unplug
from outlet when not in use or before cleaning.
3. This appliance is not a toy, when used by or near children, close
attention is necessary, and store this appliance to a safe place, out
of the reach of children.
4. Do not use any bags or attachments not recommended or appointed,
and don’t use this appliance for other purpose except its intended
use.
5. Stop using the machine immediately if the cord is damaged and
have it replaced by a professional.
6. Keep away from moving parts.
7. Do not contact the hot sealing element located on edge of the top
cover of this machine. The component is hot and may scalding
8. Do not try to repair this appliance by yourself.
9. Don't use the appliance if it has fallen or appeared to be damaged.
10. Avoid to do the following: pull or carry by the cord, use cord as a
handle, close a door on cord, or pull cord around sharp edges or
corners. Do not operate appliance over cord or cord / plug is wet.
- 1 -
11. Keep away from hot gas, heated oven, electric burner or any other
hot surfaces. Do not use this appliance on wet or hot surface or near
a heat source.
12. It’s better not to use an extension cord with this unit. However, if one
is used, it must have a rating equal to or exceeding the fating of this
appliance.
13. When disconnect, to avoid any injury, please unplug by grasp the
plug, not the cord.
14. Before plugging appliance in or operating, make sure your hands are
dry and safe to do the actions.
15. When it In “ON” or working position, always be on a stable surface,
such as table or counter.
16. It’s no need to use any lubricant, such as lubricating oils or water, on
this appliance.
17. Do not immerse any part of this appliance, power cord or plug in
water or any other liquid.
18. Do not use this appliance outdoors or on a wet surface, it’s
recommended for household, indoor use only.
19. This appliance can’t be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a
safe way and understand the hazards involved.
20. Children should be supervised to ensure that they do not play with
the appliance.
21. If the supply cord is damaged, It must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
22. Cleaning and user maintenance shall not be made by children
without supervision.
- 2 -
CAUTION:
SAVE THESE INSTRUCTIONS
FOR HOUSEHOLD USE ONLY
CONSTRUCTION AND FUNCTIONS
1. Vacuum&seal : At stand-by condition, it starts the automatic operation of
vacuuming the bag and then automatically seals the bag when
vacuum is complete;
2. Cancel:
● At working (vacuuming or sealing operations) condition, it stops the
machine.
3.Vacuum Time Screen: This screen is the numeric display apparatus and
provides two functions
● show that the progress of vacuuming;
● show that setting vacuum time.
4.Seal Time Screen: This screen is the numeric display apparatus and provides
two functions
● show that the progress of sealing;
● show that setting sealing time.
5.Set:To chose setting the vacuum times or sealing times.Vacuum times set
range:15-60s;sealing times set range:3-9s.
6. “+”:To increase the vacuum times or sealing times.
7. “-”:To decrease the vacuum times or sealing times.
8. Seal: This button provides also two functions:
● To seal the open end of a bag, used to make a bag from a bag roll;
When seal the bags, the machine will start the vacuuming firstly about 7
seconds to keep tightness of the sealing bar before it seal the bags.
● When the automatic “Vacuum &seal” function is in operation, this button
stops the motor pump when the vacuum pressure reached about -25inHg
which indicated on the pressure gauge, press the "SEAL" button to seal the
- 3 -
bags immediately so that less vacuum pressure inside the bag can be
achieved by the operator to avoid crushing for delicate items.
9.Marinate：Work on vacuum 60s and no seal.
10.Vacuum Gauge:Represents the vacuum level inside the chamber.
11.Gasket：Keep air away by forming vacuum chamber with gasket. Clean and dry
or replace it when distorted or broken.
12. Sealing element: Teflon-coated heating element which is hot and seals the
bag.
13.Sealing strip: Place the bag to be sealed over this strip, Clean and dry or
replace it when distorted or broken.
14.Bag fixer: Fix and splitter the bag mouse when vacuum and
sealing.
15. Air extraction: Draw out the air in
- 4 -
OPERATING INSTRUCTIONS
III. Making a bag with bag roll
Put out the power cord and plug to the appliance and a wall
outlet,Switch turn “ON”,Vacuum screen and seal screen will display
working time.Set suitable vacuum and sealing time.
1.Pull out the bag roll and cutter to the suitable length you want.---Fig.1
Fig.1
- 5 -
2.Open the cover put one end of the bag on top of the sealing element
and make sure that the entire short end is under bag fixer.---Fig.2
3.Pull down the cover and touch “ Seal” button to start make the bag. Lf
done the digital tube will go to zero
2.Open the cover. Remove the finished vacuum bag. The vacuum bag is
now ready to be used for vacuum packing.
II. Vacuum packaging with a bag
1. Put the food in the bag, clean and stretch the bag to make sure there
are no wrinkles and ripples.
Note: put the bag in the inner pressure bag scaffold and drain the
excess air from the bag. This is a very important point to get a good
vacuum seal bag.
2.Open the cover put one end of the bag on top of the sealing element
and make sure that the entire short end is under bag fixer.– Fig. 1
Fig.3
Fig.2
- 6 -
3.Check to confirm vacuum and sealing time according to the type
of food and bag.
4. Pull down the cover and touch “Vacuum&Sealing” button to start the
unit start to vacuum and will seal the bag automatically . If the program is
complete. The countdown to the digital tube is over. The digital tube will
return to the initial state . -Fig.2
Note: The appliance reaches a very high vacuum pressure
during the vacuum sealing process. In order to avoid that
sensible contents is influenced by the high pressure, press the
Manual Seal button, if you want to interrupt the process before
time. In such case, the appliance turns off the pumping and
switches to sealing of the vacuum bag.
5. Lift the handle to open the cover and take out the packed bags-Fig.3
Fig.2
Fig.1
- 7 -
NOTE:
⚫For best sealing effect, it is better to let the appliance cool down
for 1 minute before using it again. Wipe out any excess liquid or
food residue in the vacuum chamber after each bag packaged.
⚫The machine can be used continuously.
⚫Your appliance can work all on the specific bags.
⚫Cut the bag straight across with scissors to open a sealed bag.
Note: When put the bag into the vacuum chamber, Please put the
bag mouse encircle the splitter plate toavoid the air cann’t be draw
out completed from the bag
Fig.3
- 8 -
Working on marinate
1.Put the marinade in the bag
2.Lift the handle to open the cover and put the container on chamber.
-Fig.1
3.Pull down the cover and touch “Marinate” button to start the unit start
to vacuum. indicator LED off if finish one circulation. -Fig.2
4.Repeat step 3 two more.
5.Lift the handle to open the cover and take out the items.
Use an external jar
1.Insert one end of the hose into the air intake and another end of the
hose into the center hole of the canister cover- Fig. 1;
Fig.1
Fig.2
Table des matières
Autres manuels Adexa Food Saver
