BEFORE USE
Please insert power supply plug into the wall outlet ,singte-phale to cat voltage.
Allow the unit to operate for about 1 hour to cool the compartment before placing items in the cooler.
Remove shipping package, tape, etc, and leave doors open ventilation for a while.
The unit is cleaned before shipment. However, clean the compartment interior once after delivery.
WAIT 5 MINUTES OR MORE BEFORE RE-STARTING
Restarting the unit immediately after it has been turned off may cause fuses to blow and activate the
circuit-breaker, the compressor may be overloaded, and/or other damage may occur.
TEMPERATURE ADJUSTMENT
For showcase cooler,the interior temp.during fully loaded at factory default setting of position at 4-5 will
be kept at 0-10'c ,If the ambinet temp.is extremely high or the stuffing food inside is too much,that might
cause the interior temp.a little bit higher.so,it would be better tum the thermostat right so as to maintence
the right temp.On the opposite,if the ambinet temp.is very low or empty loaded,or in less food storage,the
interior temp.might be able to reach minus0'c,and in return to cause the evaporator ice up;Thus,it would
better switch the thermostat back to left so as to relieve something.
DRAIN TRAY
Defrosting is performed automatically and drain water is collected in the drain tray.
Water is in the drain tray is evaporated automatically. In humidity, large amount of water in the drain
tray, so please throw away drain water once a day.
EFFICIENT USE
To prevent cold air from escaping, open and close the door quickly and keep the door opened
for as short a time as possible.
Please install the unit in the place which is well-ventilated.
Please follow the below instruction, you could save energy.
SHELF HEIGHT ADJUSTMENT
Arrange the shelves in accordance with the dimensions of the items to be placed in the cooler.
The shelf height can be adjusted.
PLACING ITEMS IN THE SHOWCASE
This showcase employs a forced circulation of cold air system. If circulation of cold air is obstructed,
the items will not be adequately refrigerated. Pay attention to the following points:
Do not let items obstruct the cold air inlet and suction outlet.
Place items so that they do not protrude from the shelves. The gap between the shelves and the
door is used for circulation of cold air.
Place items evenly on all shelves.
Please do not display goods on the bottom. Please put goods on the shelf.
HOW TO USE
5
