SAFETY INSTRUCTIONS FOR INSTALLATION, INSPECTION AND MAINTENANCE
WORKS
As a basic principle, works may only be carried out to the equipment when it is shut
down. Pumps or plant that convey harmful substances must be decontaminated. All
safety and protection components must be re-fitted and/or made operational
immediately after the works have been completed. Their effectiveness must be
checked before restarting, taking into account the current regulations and
stipulations.
UNAUTHORISED MODIFICATIONS, MANUFACTURE OF SPARE PARTS
The equipment may only be modified or altered in agreement with the manufacturer.
The use of original spare parts and accessories approved by the manufacturer is
important for safety reasons. The use of other parts can result in liability for
consequential damage being rescinded. All materials in contact with water have been
tested and approved, therefore only original replacement parts should be used.
UNAUTHORISED OPERATING METHODS
The operational safety of the supplied equipment is only guaranteed if the
equipment is used for its intended purpose. The limiting values given in the
“Technical Data” section may not be exceeded under any circumstances
INSTRUCTIONS REGARDING ACCIDENT PREVENTION
Never work alone. Always wear a hard hat, safety glasses and safety shoes and, if
necessary, a suitable safety belt. Before carrying out welding works or using electrical
devices, check to ensure there is no danger of explosion.
For the sake of your health, be sure to pay meticulous attention to cleanliness
wherever you are working. Make sure that there are no toxic gases in the working
area
Observe the relevant occupational health and safety regulations and keep first aid
materials available.
In some cases, the pump and the pumping medium may be hot and could cause
burns. For installations in areas subject to explosion hazards, special regulations
apply!
DANGER - ELECTRIC SHOCK RISK
230v Pumps - The pump must only be connected to sockets that have been installed
properly in accordance with the regulations and are protected with safety switch
(RCD,30mA)
Only qualified electricians may carry out electrical works to the pump or the controls
Always pull out the mains plug before carrying out any work on the pump
Check the rubber hose for mechanical or chemical damage. A damaged or kinked
hose must be replaced.
