Accessory Power Koala Pal Manuel utilisateur
INSTRUCTION MANUAL
TM
KO AL A
PA L
Thank you
for purchasing the GOgroove™ Koala Pal.
This compact, portable speaker system is a
fun and unique pairing for your laptop, iP-
hone®, iPod®, iPad®, MP3 player, smartphone
or other audio device. You’ll be surprised just
how much this little Koala rocks!
Koalas are famous and loved worldwide
as Australia’s cute and cuddly icon of the
bush. However, their survival is threatened
by habitat loss, dog attack, bush re and
disease.
The Australian Koala Foundation is the pre-
mier not for prot organization dedicated
to saving the wild koala and its habitat, but
with numbers rapidly approaching unsus-
tainable levels, their situation is now critical.
Adopt your own koala, plant a food tree
or see other ways to help the Koala at
www.savethekoala.com.
Please join Accessory Power™
in supporting the Australian
Koala Foundation
TM
KO AL A
PA L
Product Diagram
What’s in the box?
- Koala Pal™ Speaker
- USB power cable
fig. 1
fig. 2
1- Volume control
2- 3.5mm audio cable
3- USB power port
4- ON/OFF switch
5- AAA battery compartment
6- Power LED
1
2
3
4
5
6
You can power the GOgroove™ Koala Pal™ using USB or AAA batteries.
For USB power, connect the smaller end of USB power cable to the (3) USB power
port on the back of Koala Pal (g. 2). Next, connect the large end of the USB
power cable to the USB port of your computer. Make sure the (4) ON/OFF switch on
the bottom of Koala Pal is switched to the ON position. The (6) Power LED on the
front of Koala Pal will glow blue when power is being supplied. Now just connect
the Koala Pal’s (2) 3.5mm audio cable to the headphone port on your device and
you are ready for music! Refer to the setup diagram below (g. 3). For volume
adjustment, you can use Koala Pal’s (1) Volume control and your device’s volume
adjustment setting.
***Note: If you do not want to connect Koala Pal to USB power, you can use 3
AAA batteries for power while listening to laptop/computer music. In this case,
you only need to connect Koala Pal’s (2) 3.5mm audio cable to your computer’s
headphone port.
Operating Instructions:
Listening to Music from a Laptop/Computer:
USB power cable
3.5 mm audio cable
fig. 3
Listening to Music from an MP3 player, iPod®, iPhone®, cell
phone or other device:
For power, please insert 3 AAA batteries into the (5) AAA battery compartment
located on the bottom of Koala Pal (g. 2). Make sure the (4) ON/OFF switch on
the bottom of Koala Pal is switched to the ON position. The (6) Power LED on the
front of Koala Pal will glow blue when power is being supplied. Now, just connect
the Koala Pal’s (2) 3.5mm audio cord to the headphone port on your device and
you are ready for music! Refer to the setup diagram below (g. 4). For volume
adjustment, you can use Koala Pal’s (1) Volume control and your device’s volume
adjustment setting.
3.5mm audio cable
audio device
fig. 4
If you are having trouble playing music, please make sure you have done
the following:
- Connect the Koala Pal to a power source: You will know that Koala Pal is
receiving power because the (6) Power LED will glow blue. If it is not glowing
blue, please make sure that it is either connected to a USB power port or that
you have properly inserted 3 working AAA batteries. Make sure the (4) ON/OFF
switch on the bottom of Koala Pal is switched to the ON position.
- Connect Koala Pal to an audio source: Please make sure that the (2) 3.5mm
audio cable is fully inserted into your audio device or computer. Next, make sure
that the device you are using as the audio source is properly playing music and
that your device’s volume setting is turned up.
- Adjust Koala Pal’s volume setting: Make sure that Koala Pal’s volume
setting is turned up by adjusting the (1) Volume control.
- Keep in a safe place free from dust, liquid and extreme temperatures
- Only use this device with the recommended power sources
- Keep out of reach of small children
- When not in use, please disconnect batteries or power sources
Troubleshooting
Cautions
Product Specications
Dimensions: 3.7 x 3.7 x 2.75 inches (9.4 x 9.4 x 7 cm)
Speakers: 2 x 1W RMS
Drivers: 1.5 inch x 2 high excursion drivers
Audio Input: Standard 3.5mm headphone plug
Power: USB 5 volt, or 3 AAA batteries not included
©2011 ACCESSORY POWER
All trademarks and brand names are the property of their owners.
iPhone® and iPod® are trademarks of Apple, Inc.
registered in the U.S. and other countries.
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels Accessory Power Intervenants
Accessory Power
Accessory Power GOgroove SideStream Manuel utilisateur
Accessory Power
Accessory Power GOgroove BlueSYNC SRC Manuel utilisateur
Accessory Power
Accessory Power GO groove SonaVERSE CRS Manuel utilisateur
Accessory Power
Accessory Power Go groove move Manuel utilisateur
Accessory Power
Accessory Power ENHANCE ENPCSL2100BLEW Manuel utilisateur
Accessory Power
Accessory Power GO groove SonaVERSE BSE Manuel utilisateur
Accessory Power
Accessory Power GOgroove Panda Pal Manuel utilisateur
Accessory Power
Accessory Power GOgroove Manuel utilisateur
Accessory Power
Accessory Power GO groove SonaVERSE LBr Manuel utilisateur
Manuels Intervenants populaires d'autres marques
Bowers & Wilkins
Bowers & Wilkins 4 Manuel utilisateur
Sonance
Sonance SONOS OUTDOOR Series Manuel utilisateur
Electro-Voice
Electro-Voice EVID FM4.2 Manuel utilisateur
Pioneer
Pioneer XW-HTD630 Manuel utilisateur
Onn
Onn BWA16AA002 Manuel utilisateur
HP
HP GL313AA - USB Speakers PC Multimedia Manuel utilisateur