Acaia AP009 Manuel utilisateur

Acaia Pearl

User Manual

FW 1.0.010

AP007 / AP008 / AP009

In The Box

Introduction

Scale Overview

Getting Started

Placement

Power On / Off

Tare Weight

Switch Modes

Toggle Units

Product Care Information

Battery Charge

Battery Indicator

Calibration

Flow-Rate Indicator

Mode Introduction

Mode 1 - Weighing Only Mode

Mode 2 - Dual Display Mode

Mode 3 - Pour Over Auto-Start Timer Mode

Mode 4 - Portafilter Mode

Mode 5 - Beverage Mode

Configuration

Appendix

Buttons

LED Indicators

Error Codes

Other

Specifications

Contents

Next, follow the instructions in the “Getting Started” section to begin using your scale. To take

advantage of all the features of the Acaia Pearl, carefully read through this user manual for

step-by-step procedures, examples, and other information.

Warning: Incorrect handling of this product could result in personal injury or physical damage.

Thank you for choosing one of our scales. The Acaia Pearl is designed and manufactured

to the most rigorous standard to give you the best coffee brewing experience. First, check

inside the box to find the following:

* Note: For the best performance, place the weight in the center of the weighing platform.

In The Box

Introduction

Scale Overview

Weighing Pan

LED Display

Power

Charging /

Low Battery Indicator

Tare

Acaia Coffee Scale Heat Resistant Pad USB Type-C Cable

[Press and hold] to toggle between units.

Getting Started

Placement

Power On / Off

Tare Weight

Switch Modes

Toggle Units

Place the scale on a stable and vibration-free surface at a preferably

horizontal location.

[Press] to turn on the scale.

[Double tap] to turn off the scale.

[Tap] to tare / zero the weight.

[Press and hold] to switch between modes.

* Please see the “Mode Introduction” section for more details.

You can charge the battery by plugging the USB Type-C

cable into any of the power supplies listed below:

• A computer

• A USB wall-charger with an output of 5 volts and 1 amp

• A USB-C PD charger supporting 5 volts

• A DC car-charger with an output of 5 volts and 1 amp

• Press and hold the Power button while the LED display shows [ ACAIA ] and then changes

to [ SEt ].Continue to hold the Power button until the battery percentage is displayed.

* Note: The Acaia Pearl is equipped with charging protection to prevent the battery from charging

under high temperatures. It is normal if the scale does not charge when the surface is hot from

brewing coffee. Battery charging function will be enabled once the scale has cooled.

Turn on the Acaia scale. Make sure the scale is

in Weighing Only Mode

and the unit is set to

‘gram’, then tap the ‘T’

button rapidly.

Keep tapping the ‘T’

button until ‘CAL’ is

shown on the display.

Place a weight

(100g/500g/1000g)

on the scale and wait

until the display shows

‘_End_’. Calibration is

now complete!

Product Care Information

Turn on scale Tap Tare button See CAL display Place a weight

Battery Charge

Calibration

Battery Indicator

• It takes about 1-2 hours to fully charge the battery when the battery is empty. Try not to

let the battery completely run out before charging. Charge the battery as needed.

• A fully charged battery can work continuously for about 30 hours.

• Remaining battery power can be viewed when the scale is off by pressing and holding the

Power button until the Battery Indicator comes on. You can also check the battery power by

connecting the scale to Acaia Apps.

Flow-Rate Indicator

The Flow-Rate Indicator is an LED bar on the top of the display. It helps you visualize your

pouring speed in real time and suggests thresholds for ideal ow rates. The indicator measures

ow rates with lit LEDs starting from 0.5 g per second in the center to 9.5 g per second at both

ends. When the ow rate exceeds 11.5 g per second, the last three LEDs will light up with

enhanced brightness, indicating a high ow rate.

To provide thresholds for ideal ow rates, the rst pair of the brighter LEDs represents 2.5 g per

second. The second pair of brighter LEDs represents 6.5 g per second, for targeting a faster

pouring speed.

The Flow-Rate Indicator can be activated in Dual Display Mode, Pour Over Auto-Start Timer

Mode, and Beverage Mode. You can turn the indicator on or off in the advanced settings menu.

Flow Rate > 2.5 g/s Flow Rate > 6.5 g/s Flow Rate > 11.5 g/s

Mode Introduction

In the Weighing Only Mode, the scale will only display weight

in either grams or ounces.

• There are two different weighing units in Weighing Only Mode: gram and ounce.

• In grams, the LED display shows [ 0.0 ].

• In ounces, the LED display shows [ 0.000 ] and the Weighing In Ounces Indicator on the

bottom left lights up.

Mode 1 - Weighing Only Mode

Action Operation

Tare Weight Tap Tare button

Toggle Units g / oz Press and hold Tare button

Reset Mode Double tap Tare button

Switch Mode Press and hold Power button

In the Dual Display Mode, the scale displays [ 0:00 0.0 ]

with a timer (left) and weight (right).

• There are two different weighing units in Dual Display Mode: gram and ounce.

• In grams, the LED display shows [ 0:00 0.0 ].

• In ounces, the LED display shows [ 0:00 0.000 ].

• The timer displays from [ 0:00 ] to [ 9:59 ].

• Flow-Rate Indicator is supported in this mode.

Mode 2 - Dual Display Mode

Action Operation

Start / Stop / Reset Timer Tap Power button

Tare Weight Tap Tare button

Reset Mode Double tap Tare button

Switch Mode Press and hold Power button

• In grams, the display shows [ 0.0 ] before a portafilter is placed on the scale.

• In ounces, the display shows [ 0.000 ] before a portafilter is placed on the scale.

Mode 3 - Pour Over Auto-Start Timer Mode

Action Operation

Start / Stop / Reset Timer Tap Power button

Tare Weight Tap Tare button

Reset Mode Double tap Tare button

Switch Mode Press and hold Power button

The Pour Over Auto-Start Timer Mode is designed to

aid pour over coffee brewing. The scale will detect the

start of the flow from kettle into vessel and automatically

start the timer function; the timer stops when the brewing

equipment has been removed from the scale. When the

vessel is removed from the scale, the display flashes the

final beverage weight.

• In grams, the LED display shows [ 0:00 0.0 ] with the timer on the left and the weight on

the right.

• In ounces, the LED display shows [ 0:00 0.00 ] with the timer on the left and the weight on

the right.

• The timer displays from [ 0:00 ] to [ 9:59 ].

• Flow-Rate Indicator is supported in this mode.

Mode 4 - Portafilter Mode

Action Operation

Tare Weight Tap Tare button

Reset Mode Double tap Tare button

Switch Mode Press and hold Power button

The Portafilter Mode is designed to simplify the workflow

of weighing coffee grounds in a portafilter. The scale

automatically detects a portafilter or other vessel and

tares the weight of the vessel. Remove the portafilter to

add coffee grounds, then place on the scale again to

measure the weight of the coffee grounds. Repeat as needed to adjust the weight. After

the portafilter has been removed for 15 seconds, the scale will reset the mode to default

for the next workflow.

• There are two different weighing units in Beverage Mode: gram and ounce.

• As soon as the weight is stabilized or the tare button is pressed, the next step will show in

the display.“---” indicates the scale is performing auto-tare.

• AFTER the process is completed and the filter is removed, the display will blink and flash

the time elapsed for the brew, total amount of water added, beverage weight in the carafe,

and the coffee-to-beverage ratio at the end of the brew.

Mode 5 - Beverage Mode

Action Operation

Tare Weight Tap Tare button

Next Step Press and hold Tare button

Previous Step Press and hold Power button between the steps

Stop Timer Tap Power button

Reset Mode Double tap Tare button

Switch Mode Press and hold Power button

Display Action / Description

Put the carafe/cup on the scale, press and hold the Tare button to

go to the next step.

Put the lter/dripper on the carafe/cup, press and hold the Tare

button to save the dripper weight.

Measure the amount of coffee beans you want to use. When

you’ve reached the target coffee bean weight, press and hold the

Tare button to save the weight.

The timer starts when water pour is detected. The timer stops

when you tap the Power button or remove the lter/dripper.

Remove the lter/dripper to proceed.

After the lter/dripper has been removed, the scale will display

the nal time and weight, the beverage weight, and the coffee-to-

beverage ratio.

This mode is designed to measure the coffee-to-beverage

ratio. It is one of the most consistent methods for measuring

pour over extraction. With this mode, you will be able to see

the time elapsed for the brew, total amount of water added,

beverage weight in the carafe, and the coffee-to-beverage

ratio at the end of the brew.

1. With the Pearl powered off, press and hold the Power button. When the LED display

shows [ ACAIA ] and then changes to [ SEt ], release the Power button.

2. Tap the Tare button to enter Settings. The first setting is [ SLEEP ].

3. Please refer to the following table for key operations:

Configuration

Enter Settings

Settings Menu

Action Operation

Next Setting Tap Tare button

Enter Setting Press and hold Tare button

Toggle Options Tap Tare button

Save Option Press and hold Tare button

Back to Menu Without Saving Tap Power button

Exit Settings and Return to Modes Tap Power button

Setting Display Options Default

Sleep Timer Setting SLEEP 5,10, 20, 30, 60, Off 5

Brightness Setting bright 1, 2, 3, 4 2

Battery Saving Setting bAttSAvE 30, 90, 180, Off 90

Zero Tracking Setting trAcE 0.5 d, 1 d, 2 d, 3 d, Off 2 d

Key Sound Setting bEEP On, Off On

Weighing Filter Setting FiLtEr Fast, Normal, High Fast

Default Weighing Unit Setting Unit Gram, Ounce Gram

Weighing Resolution Setting rESoL Default, High, Precise Default

Weighing Only Mode Setting NodE_1 On, Off On

Dual Display Mode Setting NodE_2 On, Off On

Pour Over Auto-Start Timer Mode Setting NodE_3 On, Off Off

Portalter Mode Setting NodE_4 On, Off Off

Beverage Mode Setting NodE_5 On, Off Off

Bluetooth Setup Setting bt_SEt On, Off On

Flow-Rate Indicator Setting FLorAtE.d On, Off On

Weight Stable Indicator Setting StAbLE.d On, Off Off

Auto Reset Setting Auto.rES 20, 60, Off 20

Portalter Auto Reset Setting Port.rES 15, 30, 60, Off 15

Reset to Default Setting rESEt.d Yes, No No

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels acaia Échelle

acaia

acaia Cinco Manuel utilisateur

acaia

acaia Pearl S Manuel utilisateur

acaia

acaia Pearl Fiche technique

acaia

acaia AL010 Manuel utilisateur

acaia

acaia AC001 Manuel utilisateur

acaia

acaia Pearl Manuel utilisateur

acaia

acaia Pearl Manuel utilisateur

acaia

acaia lunar Manuel utilisateur

acaia

acaia lunar Manuel utilisateur

acaia

acaia Pearl S Manuel utilisateur

acaia

acaia Pearl Manuel utilisateur

acaia

acaia lunar Manuel utilisateur

acaia

acaia Pearl Manuel utilisateur

acaia

acaia Pearl Fiche technique

acaia

acaia pearl coffee scale Manuel utilisateur

acaia

acaia Pearl Manuel utilisateur

acaia

acaia lunar Manuel d'installation

acaia

acaia Coffee Scale Manuel utilisateur

acaia

acaia Pyxis Manuel utilisateur

acaia

acaia PS001 Manuel utilisateur

acaia

acaia Pearl S Manuel utilisateur

acaia

acaia Pearl Manuel utilisateur

acaia

acaia Pearl Manuel utilisateur

acaia

acaia AC002 Manuel utilisateur

Manuels Échelle populaires d'autres marques

AWS

AWS ZEO-50 Manuel utilisateur

Gima

Gima Glass Body Fat Analyzer Manuel de la liste des pièces

Seca

Seca 374 Manuel utilisateur

TEC

TEC TEC SL59 SERIES Manuel utilisateur

Axis

Axis B/E Series Manuel utilisateur

Alecto

Alecto ACW-40 Manuel utilisateur

Rice Lake

Rice Lake MSI-4260 IS Manuel utilisateur

IKA

IKA RCT basic safety control Manuel utilisateur

ADE

ADE M20011 Manuel utilisateur

Duronic

Duronic KS3000 Manuel utilisateur

Digi

Digi SM-720 Manuel utilisateur

Cardinal

Cardinal CS Series Manuel utilisateur

Korona

Korona Kastella Manuel utilisateur

A&D

A&D FC-50Ki Manuel utilisateur

BDA

BDA CAMARGUE Manuel utilisateur

Tanita

Tanita HD-357 Manuel utilisateur

Leifheit

Leifheit 03173 Manuel utilisateur

Lumme

Lumme LU-1340 Manuel utilisateur

acaia AP009 Manuel utilisateur

Manuels Échelle populaires d'autres marques