AiBox 3.1User Manual
2
The following marks on the product and in this manual indicate important safety measures.
WARNING: Be sure to understand and follow all safety guidelines, safety instructions,
warnings and precautions listed in this manual.
This product is for professional use only!
This product may result in serious injury or death due to fire hazard, electric shock, and
crushing hazard.
Please read this manual carefully before installing, powering up, operating and maintenance
of this product.
Follow safety instructions in this manual and on the product. If you have any questions,
please seek help from Absen.
Beware of Electric Shock!
• To prevent electric shock the device must be properly grounded during installation. Do not
ignore using the grounding plug, or else there is a risk of electric shock.
•During a lightning storm, please disconnect the device’s power supply, or provide other
suitable lightning protection. If the equipment is not in use for a long time,
please unplug the power cord.
• When performing any installation or maintenance work (e.g. removing the fuses, etc.,)
make sure to turn off the master switch.
•Disconnect AC power when the product is not in use, or before disassembling, or
installing the product.
•The AC power used in this product must comply with local building and electric codes, and
should be equipped with overload and ground fault protection.
•The main power switch should be installed at a location near the product and should be
clearly visible and easily reached. This way in case of any failure the power can be
promptly disconnected.
• Before using this product check all electrical distribution equipment, cables and all
connected devices, and make sure all meet current requirements.
•Use appropriate power cords. Please select the appropriate power cord according to the
required power and current capacity, and ensure the power cord is not damaged, aged or wet.
If any overheating occurs, replace power cord immediately.
•For any other questions, please consult a professional.
Beware of Fire!
•Use a circuit breaker or fuse protection to avoid fire caused by power supply cables
overloading.
• Maintain good ventilation around the display screen, controller, power supply and other
devices, and keep a minimum 0.1 meter gap with other objects.
• Do not stick or hang anything on the screen.
