3M Pro-Protect Manuel utilisateur
PRO-PROTECT PRO-COMMS
Electronic Hearing Protection
Basic Operations . . . . . . . . . . . . . . . . . . . . . . . 4 – 6
Bluetooth®Operations. . . . . . . . . . . . . . . . . . . 7 – 8
Navigation . . . . . . . . . . . . . . . . . . . . . . . . . . .9 – 10
Microphone placement . . . . . . . . . . . . . . . . . . . . . 11
Communications set-up Instructions. . . . . . . . .12 – 13
HARD HAT Attachment . . . . . . . . . . . . . . . . . . .14 – 21
Safety Information . . . . . . . . . . . . . . . . . . . .22 – 24
NOISE Reduction Rating (NRR) . . . . . . . . . . . . . . 25 – 31
PRO-PROTECT PRO-COMMS
Electronic Hearing Protection
BASIC OPERATIONS
PRO-PROTECT PRO-COMMS ELECTRONIC HEARING PROTECTION
4 English
Install two 1.5V AA batteries as shown.
Replace battery door top-end first.
Note:
• Do not mix old and new batteries
• Do not mix alkaline, standard or
rechargeable batteries
Release the latch by pushing upwards.
Battery door will hinge open.
Installing Batteries:Installing Batteries:
1.5V AA
batteries
English 5
BASIC OPERATIONS
PRO-PROTECT PRO-COMMS ELECTRONIC HEARING PROTECTION
Press and hold power button for 3 seconds to power
ON/OFF headset. Voice Assist will announce “Power
ON” or “Power OFF.”
Adjust ambient volume by selecting one of the four
levels by pressing the volume button (SPEAKER).
To mute the ambient volume, press and hold the
volume button. While muted, press the volume
button once to return to your last volume setting.
Performance is best when volume is set to lowest
level needed for conversation.
Power and Volume:
Fully extend sliders and place cups over ears so
that microphones are facing forward. Then, tighten
headband using sliders.
Fitting Headset:
POWER/
BLUETOOTH®
VOLUME
6 English
BASIC OPERATIONS
PRO-PROTECT PRO-COMMS ELECTRONIC HEARING PROTECTION
Headset will give a “Battery Low” warning every
20 minutes when battery voltage is low. Additional
warnings will occur as hearing protector powers
down. Replace batteries at this time.
After a period of inactivity for 4 hours, a 10-second
countdown will begin before hearing protector
automatically powers down. To reset Auto Shut-Off,
simply adjust volume. After Auto Shut-Off, press
and hold the power button for 3 seconds to turn
the unit on.
Low Battery Warning: Auto Shut-Off:
AUTO
SHUT-OFF
BATTERY
LOW
POWER/
BLUETOOTH®
VOLUME
English 7
BASIC OPERATIONS
PRO-PROTECT PRO-COMMS ELECTRONIC HEARING PROTECTION
Pair Device Function: Once Your Device is Paired:
BLUETOOTH®
PAIRING ON
BLUETOOTH®
CONNECTED
Double-press the Bluetooth® button to enter
pairing mode. You will hear “Bluetooth Pairing”.
Make sure your Bluetooth® enabled device is
scanning/searching for devices. Check your device
to make sure it has discovered “3M Pro-Protect”
or “3M Pro-Comms” as appropriate. Select to
connect to the hearing protector.
Once connected successfully, you will hear
“Bluetooth Connected”.
Once your device has been connected successfully
to the “3M Pro-Protect” or “3M Pro-Comms” as
appropriate, it will automatically link the next time
you turn on the hearing protector. A “Bluetooth
Connected” voice message will play once the
connection is successfully established.
POWER/
BLUETOOTH®
8 English
BLUETOOTH®OPERATIONS
PRO-PROTECT PRO-COMMS ELECTRONIC HEARING PROTECTION
To answer or disconnect a call, press the
Bluetooth® button once.
To reject a call and return to Bluetooth® from
a “3M Pro-Protect” or “3M Pro-Comms,” press and
hold the Bluetooth® button.
After disconnecting from the call you will hear
“Call terminated”.
The typical range between a Bluetooth®enabled
device and the 3M Pro Electronic Hearing Protectors
is approximately 25 feet. This distance may vary
depending on the device. As the distance between
the Bluetooth®enabled device and the hearing
protector increases, the risk of the signal dropping
also increases.
For best results, keep your Bluetooth®enabled
device on your body or within an arm’s length of
the 3M Pro Electronic Hearing Protectors while
using Bluetooth®Mode.
MAXIMUM
25 FEET
Incoming Calls, Messages, Alerts
& audio Playback:
3M PRO electronic Hearing
Protectors Wireless
Bluetooth®Range:
PAUSE/PLAY
Press once
ADVANCE
TRACKS
Double Press Quickly
PREVIOUS
TRACKS
Triple Press Quickly
ANSWER /
TERMINATE CALL
Press once
REJECT A CALL
Press and hold
English 9
NAVIGATION
PRO-PROTECT ELECTRONIC HEARING PROTECTION
ON/OFF
Hold three seconds
POWER/
BLUETOOTH®
Double press to pair
SINGLE PRESS
to toggle
volume level
SINGLE PRESS
to return from mute
to last setting
PRESS & HOLD
to mute
10 English
NAVIGATION
PRO-COMMS ELECTRONIC HEARING PROTECTION
SINGLE PRESS
To toggle
volume level
SINGLE PRESS
To return from mute
to last setting
PRESS & HOLD
To mute
ON/OFF
Hold three seconds
E
X
T
P US H -TO -TA L K
Button
POWER/
BLUETOOTH®
Double press to pair
Autres manuels pour Pro-Protect
1
Ce manuel convient aux modèles suivants
1
Table des matières
Langues :
Autres manuels 3M casque
3M
3M PELTOR WS ALERT X Manuel utilisateur
3M
3M PELTOR PIC-100 Manuel utilisateur
3M
3M PELTOR HT 79 Series Manuel utilisateur
3M
3M PELTOR WS ALERT XP Series Manuel utilisateur
3M
3M PELTOR ComTac XPI MT20H682FB Series Manuel utilisateur
3M
3M Peltor WS Alert XP MRX21*WS5 Series Manuel utilisateur
3M
3M Peltor SportTac Manuel utilisateur
3M
3M PELTOR CH-3 FLX2 Manuel utilisateur
3M
3M PELTOR HRXD7A-01 Manuel utilisateur
3M
3M Peltor Twin Cup MT72H540P3 50 Series Manuel utilisateur
3M
3M G5 Manuel utilisateur
3M
3M G5 Manuel utilisateur
3M
3M PELTOR ComTac VI Manuel utilisateur
3M
3M PELTOR WS LiteCom Pro III MT73H7 4D10EU Manuel utilisateur
3M
3M PELTOR WS LiteCom Pro III Series Manuel utilisateur
3M
3M MRX21A2WS6 Manuel utilisateur
3M
3M PELTOR WS LiteCom Pro III Manuel utilisateur
3M
3M HEADSET C1060 Manuel du propriétaire
3M
3M MT*H7AWS5 Manuel utilisateur
3M
3M XT-1 Manuel utilisateur
