Voltronic Power Bonnie 50W Manuel utilisateur
6 hours
1. Introduction
The UPS is exclusively designed for communication devices such as hub, switch and modem.
Featuring with dynamic voltage regulator, the UPS can ensure stable DC power to connected
loads as utility. The built-in DC start function enables the UPS to be started up without a
supply of AC power. The main features of this UPS are listed below:
Dual DC outputs
Microprocessor controlled guarantees high reliability
Compact size for standing and mounting flexibility
Supports solar powered devices and communication applications
Auto restart while AC is recovering
Off-mode charging
Overload protection and short circuit protection
2. Product Overview
Front View:
Back View:
AC input
2 x 12VDC output screw terminals
3. Installation and Initial Startup
NOTE: Before installation, please inspect the unit. Be sure that nothing inside
the package is damaged.
Placement & Storage Conditions
Install the UPS in a protected area that is free of excessive dust and has adequate air flow.
Please place the UPS away from other units at least 20 cm to avoid interference. Do NOT
operate the UPS where the temperature and humidity is outside the specific limits. (Please
check the specs for the limitations.)
Connect to Utility and Charging
Plug in the AC input cord to the wall outlet. For the best results,
suggest charging the battery at least 6 hours before initial use.
The unit charges its battery while connecting to the utility.
Connect the Loads
There are two options for output terminals: 6VDC/12VDC and 12VDC/24VDC. Please verify
acceptable voltage of connected device before connecting the wires. Then follow terminal
printing to connect the positive and negative terminals to the devices.
Turn On/Off the Unit
Turn on the UPS unit by pressing and holding the power switch for 4 seconds. Turn off the
UPS unit by pressing and holding again the power switch for 4 seconds. Connected devices
will be protected by the UPS when turning on the UPS.
Indicators & Alarm Table for Operation
Conditions
Visual Indicator
Alarm
AC Mode
Green LED lighting
Off
Battery Mode
Yellow LED lighting
Sounding every 10 seconds
Low battery at battery
mode
Yellow LED flashing
Sounding every second
Fault
Red LED lighting
Continuously sounding
Bonnie 50W DC UPS Quick Guide
V. 1.0
Power switch
AC mode indicator: green lighting
Battery mode indicator:
yellow lighting indicates battery mode
yellow flashing indicates low battery
Fault indicator: red lighting
4. Important Safety Warning (SAVE THESE INSTRUCTIONS)
CAUTION! To prevent the risk of fire or electric shock, install in a temperature and humidity
controlled indoor area free of conductive contaminants. (See the specifications for the
acceptable temperature and humidity range.)
CAUTION! To reduce the risk of overheating the UPS, do not cover the UPS' cooling vents and
avoid exposing the unit to direct sunlight or installing the unit near heat emitting appliances
such as space heaters or furnaces.
CAUTION! Do not allow liquids or any foreign object to enter the UPS. Do not place beverages
or any other liquid-containing vessels on or near the unit.
CAUTION! In the event of an emergency, press the OFF button and disconnect the power
cord from the AC power supply to properly disable the UPS.
CAUTION! Do not attach a power strip or surge suppressor to the UPS.
CAUTION! If the UPS is with metal chassis, for safety purpose, grounding is a must during
UPS installation in order to reduce leakage current below 3.5mA.
CAUTION! Servicing of batteries should be performed or supervised by personnel
knowledgeable of batteries and the required precautions. Keep unauthorized personnel away
from batteries.
CAUTION! When replacing the batteries, use the same number and type of batteries.
CAUTION! Internal battery voltage is 12VDC. Sealed, lead-acid, 6-cell battery.
CAUTION! Do not dispose of batteries in a fire. The battery may explode. Do not open or
mutilate the battery or batteries. Released electrolyte is harmful to the skin and eyes.
CAUTION! Unplug the UPS prior to cleaning and do not use liquid or spray detergent.
CAUTION! A battery can present a risk of electric shock and high short circuit current. The
following precaution should be observed before replacing batteries:
1) Remove watches, rings, or other metal objects.
2) Use tools with insulated handles.
3) Wear rubber gloves and boots.
4) Do not lay tools or metal parts on top of batteries.
5) Disconnect charging source prior to connecting or disconnecting batteries terminal.
5. Trouble Shooting
Use the table below to solve minor problems.
Problem
Possible Cause
Solutions
No LED display on the
front panel,
Low battery.
Charge battery at least 6 hours.
Battery fault.
Replace with the same type of
battery.
UPS is not turn on
Press the power switch again
Alarm continuously
sounds when the
mains is normal.
UPS is overload.
Remove some loads first. Before
reconnecting equipment, please
verify that the load matches the UPS
capability specified in the specs.
UPS fault.
Return the unit to service center.
Mains normal but
yellow LED is flashing.
Power cord is loose
Reconnect the power cord properly.
6. Specifications
Model
Bonnie-50
CAPACITY
50W
INPUT
Voltage
220 VAC
Voltage Range
160-280 VAC
OUTPUT
Voltage
Dual outputs: 12VDC and 12VDC
Voltage Regulation
10V –13.7V
Transfer Time
0 ms
EFFICIENCY
AC Mode
70% at nominal voltage (battery fully charged)
Battery Mode
>90%
BATTERY
Type & Number
12V/9Ah x 1
Charging Voltage
13.7 V ± 0.25 V
Charging
Current
At no load
3 A @ nominal voltage
At full load
0.7 A @ nominal voltage
Charging Time
4-6 hours recover to 90% capacity
PHYSICAL
Dimension (DxWxH)
228 x 82.5 x 207 mm
Net Weight (kgs)
3
Environment
Humidity
0-90 % RH @ 0-40°C (non-condensing)
Autres manuels Voltronic Power UPS
Voltronic Power
Voltronic Power Galleon II 3P Manuel utilisateur
Voltronic Power
Voltronic Power 1K Online UPS For Dual-mains Input Manuel utilisateur
Voltronic Power
Voltronic Power 6K Manuel utilisateur
Voltronic Power
Voltronic Power +Power 30U-90 Manuel utilisateur
Voltronic Power
Voltronic Power Nano 400 Manuel utilisateur
Voltronic Power
Voltronic Power Taurus UPS-7.5 Manuel utilisateur
Voltronic Power
Voltronic Power Galleon One 6K Manuel utilisateur
Voltronic Power
Voltronic Power 6K Manuel utilisateur
Voltronic Power
Voltronic Power 6K Manuel utilisateur
Voltronic Power
Voltronic Power Giant 3P/3P Manuel utilisateur
Manuels UPS populaires d'autres marques
Pylontech
Pylontech Victron & Pylontech US5000 Manuel utilisateur
Tecnoware
Tecnoware EVO DSP PLUS MM 6.8 Manuel utilisateur
Mecer
Mecer ME-1000-WTU Manuel utilisateur
Mustek
Mustek PowerMust 530(B) Plus Manuel d'installation et d'exploitation
Emerson
Emerson Liebert NXL series Manuel utilisateur
MAKELSAN
MAKELSAN BOXER SERIES Manuel utilisateur
